20 Most Recent Behringer B3031A 2-Way Active Studio Monitors - Page 7 Questions & Answers

You need to take it to the repair shop.

There are a few images and some info online, although nothing very conclusive? I would try contacting the company, I do amplifier repair and deal with company's daily, most of the time they are more than helpful... http://www.behringer.com/EN/Support/index.aspx

I would contact a service center here Find Service Center

Here is a link to the schematic BEHRINGER MX3282 SCH Service Manual free download schematics eeprom repair...

It may be likely that you've blown a fuse. This will require removal of the amplifier unit from the housing. The fuse is a 100-120 V~: 6.3 A H 250 V. You should be able to find this in most places. If the fuse is not blown, then the unit must be sent in for servicing.

Did you turn on the phantom power? Condenser mics need phantom power(unless the have their own battery.)

Go to this site to download your manual. http://www.manualsonline.com

If it is one of the toggle switches on the front then IF you can get it from Behringer then it would likely already be soldered to the board. If you just want the switch try a site like mouser.com and search for toggle switch and then narrow your search from there. Not extremely easy, so contact any electronics service center and they may be able to help you as the switch is an standard off the shelf part. Good luck!

Capacitor and/or fuse has blow.

You'll need to give a lot more information on what is happening and what you are doing to get any help here

It sounds as if the input is too low. what happens if you plug whatever is going into the stereo channels into a pair of mono channels. Or are you taking about the phono stereo tape input? The stereo channels are line level whereas the other channels have both line and mic level inputs, what are you trying to put through the stereo channels? You must make sure the gain switch is set to the -10dB to get the most sensitivity (the mono channels have about -132dB max sensitivity BTW) You probably need a different mixer or possibly a submixer if you are needing more than 4 low level inputs.

What you need will depend on what you are doing with it (what sort of venues and how you are making music - what sort of band/solo with backing track etc.) You will need a monitor with an amp or a powered monitor. The key thing is that you'll be able to hear the monitor mix over the rest of the PA. If you are just putting vocals through it you would possibly be best with a 12" but otherwise go for a full range unit with 15" and horn. Power wise I would suggest you need something capable of generating at LEAST 125dB unless you are in a quiet acoustic set. The SPL from the monitor is much more important than the power since power has little bearing on SPL.

You need the correct rackmount psu, rated at 150 watts, I think it uses more than one rail volts so you can't use any old supply.

Manual for spkrs http://www.behringer.com/assets/B2520-PRO_M_EN.pdf

Needs the effects board replaced. The board is about 2"x 3" is not too expensive and easily replaced. Contact Behringer or a Behringer service center for help.

Sounds like a dodgy fader, not worth fixing as even though the part should be cheap the labour is horrific and not a DIY job.