Apex Digital HT-150 System - Answered Questions & Fixed issues
APEX DT250A digital box died
The Problem more often than not is with one or two of the electrolytic capacitors on the power board. They can be bought at Radio Shack for about $1.50 or less. You can tell if the Cap is blown by looking at the top.. it should be flat and have a x stamped in it.. if the top is cracked or "domed" the cap is bad. I just fixed one today for an employee. If you're not comfortable doing board level repairs, I suggest finding a friend. The repair took me a total of about 15 min. The Bad Cap was a 470uf 25v, but radio shack had a 35v one.. works just fine.
5/9/2020 11:49:05 AM •
Apex Digital...
•
Answered
on May 09, 2020
•
3,331 views
My converter box light wont
this is not the place where you would send it, you need to contact the people you bought it from. One thing though, when you get a new one, buy a power surge protector so that it won't burn out again.
3/16/2011 9:03:12 PM •
Apex Digital...
•
Answered
on Mar 16, 2011
•
213 views
The red light stay on
corrupt board maybe affected.. mainly its memory.. need to replace new board for that...some causes if you dont turn it of properly or either low voltage area
11/12/2010 6:39:38 AM •
Apex Digital...
•
Answered
on Nov 12, 2010
•
174 views
Digial box was working great
I have had this happen to me, also, with my Apex Digital DT-250 but it usually was a result of me using a separate remote to change the volume on my analog TV. I realize this is not the same system setup that you have but it may offer some idea.
9/18/2010 4:07:16 PM •
Apex Digital...
•
Answered
on Sep 18, 2010
•
65 views
Convert box won't turn on.
Hello,
First thing you have to do is to check for blown fuses, if found replace with the same rating type, but if otherwise thereby may be short circuited component . if you have basic knowledge in electronics,make use of a multimeter to read a component on the printed circuit board...
Hope this help you to solve the problem
9/2/2010 9:20:52 PM •
Apex Digital...
•
Answered
on Sep 02, 2010
•
42 views
Apex dt250 digital convertor-- light stays red and
If you're electronics savy, as in replacing capacitors, open it up..
that's your problem.. one or two of the caps on the power board has gone
bad.. most likely a 470uf 25v, which can be replaced with a 470uf 35v
found at Radio shack for about $1.29. You can tell if it's bad if the
top is cracked open & leaking or just domed out instead of being
flat.
9/16/2011 5:27:45 AM •
Apex Digital...
•
Answered
on Sep 16, 2011
•
780 views
Model dt 250 A will not turn on. Red on odd jewell
If you're electronics savy, as in replacing capacitors, open it up..
that's your problem.. one or two of the caps on the power board has gone
bad.. most likely a 470uf 25v, which can be replaced with a 470uf 35v
found at Radio shack for about $1.29. You can tell if it's bad if the
top is cracked open & leaking or just domed out instead of being
flat.
As far as the cc mode, I'm not sure, but this fix will get your box working
9/16/2011 5:24:35 AM •
Apex Digital...
•
Answered
on Sep 16, 2011
•
641 views
Converter wont work red light
If you're electronics savy, as in replacing capacitors, open it up.. that's your problem.. one or two of the caps on the power board has gone bad.. most likely a 470uf 25v, which can be replaced with a 470uf 35v found at Radio shack for about $1.29. You can tell if it's bad if the top is cracked open & leaking or just domed out instead of being flat.
9/16/2011 5:28:34 AM •
Apex Digital...
•
Answered
on Sep 16, 2011
•
445 views
Not finding what you are looking for?