20 Most Recent ViewSonic N2750w 27 in. HD-Ready LCD Television - Page 3 Questions & Answers


if you have a reset button (might be hidden)...hit dat

ViewSonic N2750w... | Answered on Aug 14, 2011


You likely have some failed electrolytic capacitors in the A/C to D/C power supply, The set detects the voltages produced are incorrect, or there is an overload{likely the backlight CCFL tubes}so the power supply protects itself [and you] from smoking self-destruction.
If you feel technically inclined, you can remove the back panel and do a visual inspection for leaky, bloated or popped capacitors. Replace with low-ESR of the same voltage/capacitance and size.
tom

ViewSonic N2750w... | Answered on Jul 23, 2011


You may have dying power supply or bad solder joints that go bad when heated up.
See example here:
http://s807.photobucket.com/albums/yy352/budm/VIEWSONIC/Viewsonic%20N2750W_MARCH%202005/

You need to check the caps, voltages before and after the problem occurs.

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series.

ViewSonic N2750w... | Answered on Jun 21, 2011


Sometime the game cable connections itself have bad conductivity and shorted,tries twist and shake the cable u hear humming audio and see flashes of picture in and out?Tries hook it up with a single HDMI cable cord,have a more success with many LCD tvs models.U have a HDMI cable or try Ebay.com,Amazon.com to buy one.

ViewSonic N2750w... | Answered on Jun 06, 2011


I'm not sure what input you are using,but make sure, you pick the input you are using thought the menu.

ViewSonic N2750w... | Answered on Jun 01, 2011


Just to mention that if you have Directv or Dish hooked to the TV, you may need to unplug the satelite receiver for a minute and plug back up. I have seen this happen so many times and people think their TV is at fault. And of course is the possibility of the speakers being cut off in the Sound menu which it looks like you have checked. Lastly, the problem would be in the audio board which Ebay has currently for $18 and shipping $5. Put the model number in the search field at Ebay and scroll down to the audio board.

ViewSonic N2750w... | Answered on May 21, 2011


Look for bad caps in the power supply module first.
http://s807.photobucket.com/albums/yy352/budm/VIEWSONIC/Viewsonic%20N2750W_MARCH%202005/

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series.

ViewSonic N2750w... | Answered on May 05, 2011


Yes, look for bad caps in the power supply module first.
http://s807.photobucket.com/albums/yy352/budm/Viewsonic%20N2750W_MARCH%202005/

Spark from the GROUND prong? You may have to do the Gnd LEAKAGE testing on the TV.

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series.

ViewSonic N2750w... | Answered on Mar 28, 2011


Hello
Its video decoder has damaged.
there is no repair to bd done to it, as most of its components and SMD [Suface mount Type]; and should be replaced as card. As far as sound is OK, there is no fault ot its video IF or tuner section. Video decoder is combination of digital ICs and extreme care should be taken when replacing this board. You must have through knoledge in digital electronics, and must have a concept of soldering, and have a very good quality digital multimeter to proceed. If you have these, inform me by Fixya, alongwith your email address so that I can send its schematic diagram to you. Viesonic N-2750W and Viewsonic N-2060 models have same circutary and components, except the diamention in screen size. If you are confident that you can do it by yoursel, inform me. I'ss send advice along with schematic diagram.OK.

ViewSonic N2750w... | Answered on Mar 25, 2011


Bush LCD TV model ?

ViewSonic N2750w... | Answered on Mar 16, 2011


Most likely a small surface mount fuse near the inlet of the 24v rail needed to light the tv with the backlight inverter. You may also have a CCFL bulb that is going out. If they run in a series then one bulb that is old and burning out will power down the rest of the bulbs (I ran into this problem with a 42" samsung once and that fixed it)


Thank you

HOPE this helps :)

ViewSonic N2750w... | Answered on Mar 07, 2011


Yes there is... You are going to need a VGA cable and an 1/8 audio cable (for sound)

http://support.dell.com/support/edocs/systems/ins1520/en/om_en/pdf/UX8623D.pdf - On page 29 it shows a picture of the right side of your computer. You will hook the VGA cable to the VGA port (Number 8 on the diagram).
The on your tv you will hook it up to the vga port as well. Page 7 of the following document shows a pictures of the back of your tv. You will hook it up to "L" on the diagram. Be careful to not bend the pins in the connector. http://www.viewsonic.com.au/support/manuals/files/LCd%20TV/N2750w%20User%20Guide%20English.pdf
Switch your tv over to the PC input by clicking the "Input" button. Then make sure your PC is sending a signal, you might have to hit the function key to switch the view.

ViewSonic N2750w... | Answered on Mar 05, 2011


The closed captioning (for whatever reason) may be hidden under "Parental Controls"section of the
menu.
I'm reading between the lines (no online user manual available) from:
http://www.newegg.com/Product/Product.aspx?Item=N82E16889107001

ViewSonic N2750w... | Answered on Feb 20, 2011


Which means you are not getting any video, I am guessing you have tried all inputs like video 1,2,3 etc and tuner air or cable. If you have then it's your video board.

ViewSonic N2750w... | Answered on Feb 19, 2011


check your speaker cable, may be your speaker cable didnt connect properly

ViewSonic N2750w... | Answered on Jan 17, 2011


Hi,

You could order a substitute remote ( as original is not available any longer ) from :-

http://remotes.com/store/viewsonic/n2750w.html

If you want to buy universal remote, be advised that for Viewsonic it would not be too successful and moreover, the one which is compatible ( Harmony ) would be expensive.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

ViewSonic N2750w... | Answered on Jan 10, 2011


I had a similar problem with my 42 in Philips LCD HDTV. Here was the problem. My Power Supply Board had several bad capacitors. I opened my TV (warranty was expired ofcourse) and found four bulged capacitors on the PSB. Many major electronics companiesPhilips/Magnavox, Sony, Panasonic, and others were sold capacitors that failedin 2-5 years instead of 10-20. Thecapacitors fail prematurely due to a lack of preservatives. Unfortunately, they were installed in allsorts of devices and cause a wide range of failure problems. Here are some options for you. 1. Have it fixed by a professional $$$$$$$??????? (Is itunder warranty?) Remember, TVs CONTAINHIGH VOLTAGE AND CAN KILL YOU! Do this at your own risk. 2. Open your TV and find PSB. (The board that the power cordplugs into) Check for faulty caps. If you find some (bulged or leaking) bad capsreplace the entire board. The entireboard costs around $250 right now because they are in high demand right now.They can be found at tv-part.com but supplies are limited. I would definitely shop around though. 3. Remove and then replace individual faulty caps. This takes some soldering skill. Caps are inexpensive and if you can take care of it yourselfit will save you hundreds. This may be your problem. If you determine that it might be. I have a Tip/How TO tutorialon this site that may also help. Itgives step by step instructions for replacing caps on PSB #715t2432-2. If this isyour board you are in luck. Here is theLink: Fixingthe Philips Turns/shuts off on its own problem. I'm working on uploading pictures to helpguide people though the process as well. Let me know if I can do anything to help. Hope this helps and if it does please rate itaccordingly. Good luck.Kaufman605

ViewSonic N2750w... | Answered on Dec 15, 2010


Tries unplug,replug the tv it back like about an hour later.Now ur tv is resetting back to it factory setting.Ur tv should have correct colors now.Not,than ur tv could have missing the red color.Try the tv with another incomming broadcasting signal cable in a diffrent location,see if u have good and all of it tv colors.Yes,than that location incomming broadcasting signal cable is bad.Not than the tv Tuner signal board is bad.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish Tuner signal board for the replacement.

ViewSonic N2750w... | Answered on Nov 20, 2010

Not finding what you are looking for?
ViewSonic N2750w 27 in. HD-Ready LCD Television Logo

235 questions posted

Ask a Question

Usually answered in minutes!

Top ViewSonic Televison & Video Experts

Cindy Wells

Level 3 Expert

6063 Answers

The Knight
The Knight

Level 3 Expert

76204 Answers

lubomir73

Level 1 Expert

4 Answers

Are you a ViewSonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

ViewSonic Televison & Video

  • ViewSonic Televison & Video

Most Popular Question

tv just flashes different colors

  • Televison & Video
Loading...