20 Most Recent
ViewSonic N2750w 27 in. HD-Ready LCD Television - Page 4 Questions & Answers
I'm trying to set up
try using the number keys on control an manually program numbers in that way, if you select auto tune, it will only try to program any channel it gets signal for, once you type the numbers in that way, it should ask you to save that channel number, in which of course you select yes... try that, also refer to owner manual or mfg website.
Ok I think I have seen this in a few other threads
Does the screen light up?
If it does feintly, then it probably has a processor fault if it doesn't then it may have a screen ballast fault.
Unfortunately without seeing the unit, I cannot go further.
Sorry.
I have a viewsonic N3252w
its got a bad resistor on the board, it needs to have a fan installed, because its overheating, or the resistor replaced
How do I re-program my
This is the instruction for my N2750/3250 remote.
Resetting Remote
• To reset remote and access default settings press and hold desire device button for roughly six seconds and enter three digit reset code
000.
• Replace batteries if remote control keys are not functioning properly, this is a normal behavior that indicates batteries are low.
N2750 IS 008
N1700W
001
N1300
002
N1500
003
N1750W
004
N2010
005
N2010-E
006
N2700W
007
N2750W
008
N3020W
009
N3200W
010
N3200W-E
011
VPW4255
012
VPW5500
012
N2000
014
N3000W
015
Email me if you want me to send you the full PDF from VIEWSONIC,
[email protected]
My Viewsonic N3250 has a
This is caused by the failure of a filtering capacitor in the audio amplifier section of the tv. Just open the back of the tv, locate the failed part (some testing will be necessary) unsolder it, buy an identical replacement and solder it back on the board.
I am unable to see the red color in my
a red solution? Raspberry or strawberry?
sorry couldnt resist the humour. Loss of Red is caused by components governing the red part of the color engine. This section is called convergence. Some parts of this engine can on some sets be manipulated minimally by the user in the setup menu. However once this has been tried wityhout success it's a workshop task to replca ethe engine board and completely retune it to all colors. Not a DIY
please rate my help++++Thanks for using FIXYA
Not finding what you are looking for?