ViewSonic N2750w 27 in. HD-Ready LCD Television - Page 3 - Answered Questions & Fixed issues
Ok I think I have seen this in a few other threads
Does the screen light up?
If it does feintly, then it probably has a processor fault if it doesn't then it may have a screen ballast fault.
Unfortunately without seeing the unit, I cannot go further.
Sorry.
I have a viewsonic N3252w
its got a bad resistor on the board, it needs to have a fan installed, because its overheating, or the resistor replaced
How do I re-program my
This is the instruction for my N2750/3250 remote.
Resetting Remote
• To reset remote and access default settings press and hold desire device button for roughly six seconds and enter three digit reset code
000.
• Replace batteries if remote control keys are not functioning properly, this is a normal behavior that indicates batteries are low.
N2750 IS 008
N1700W
001
N1300
002
N1500
003
N1750W
004
N2010
005
N2010-E
006
N2700W
007
N2750W
008
N3020W
009
N3200W
010
N3200W-E
011
VPW4255
012
VPW5500
012
N2000
014
N3000W
015
Email me if you want me to send you the full PDF from VIEWSONIC,
[email protected]
My Viewsonic N3250 has a
This is caused by the failure of a filtering capacitor in the audio amplifier section of the tv. Just open the back of the tv, locate the failed part (some testing will be necessary) unsolder it, buy an identical replacement and solder it back on the board.
I am unable to see the red color in my
a red solution? Raspberry or strawberry?
sorry couldnt resist the humour. Loss of Red is caused by components governing the red part of the color engine. This section is called convergence. Some parts of this engine can on some sets be manipulated minimally by the user in the setup menu. However once this has been tried wityhout success it's a workshop task to replca ethe engine board and completely retune it to all colors. Not a DIY
please rate my help++++Thanks for using FIXYA
How do I reset a Viewsonic N2759w to Factory
On most Viewsonic TVs, hit menu (on the TV or your remote) go to Options (or Setup). The icon will look like a hammer with a double ended wrench across it (at least on my TV - a different model). Hit the down arrow and select Restore Default or Memory Recall. Select Yes and Enter when you see the prompt. Then exit the menu system (by hitting menu). The action is saved when you exit.
I hope this helps.
Cindy Wells
(the two different commands results from a change in Viewsonic's menu system - my print manual differs from the current on-line manual at Viewsonic's site. I'm not sure which set of commands will apply. If your TV menus are different, the names should still be similar.)
THOMSON SCENIUM 46"
You have not given the full model number or where abouts you are. Spares are available in the uk from
[email protected] or call 01245392539 and have the correct info at hand.
The main meun locked
Is this a viewsonic? I am told, to unlock the menu, try holding the up and down channel buttons in together. If all buttons are locked, try holding the up and down volume buttons in together. The buttons are under the screen. I am not sure if you can do this while the unit is powered up or do this while powering up. Try first while unit is powered and running. Each of the two processes should set the lock if not locked and should also unlock if locked.
Audio OK no video
Ur LCD inverter board is dead.Replaced this inverter board will get ur picture back.Tries Shopjimmy.com,Ebay.com to buy a refurbish LCD inverter board for the replacement.It a long shape board.
Not finding what you are looking for?