Top 20
Toshiba 57H93 57" Rear Projection HDTV Questions & Answers
57h93 flashing screen
If the set when first turned on has noise lines or distortion (left to right usually) but after several minutes they diminish and go away you have a bad HYPER board.If this is the case let me know and I will advise you on options.
57h93 clicks only no power
these sets use a magnetic relay to turn on after a while the metal contact pads on the switch burn (just like turn signal flashers in a car)
this causes the relay to click closed but open up again before the TV can start. the relay is on the power supply board it should be labeled RL1 on the board, it is a small black or, brown plastic cube usually located next to the power cord. If all fuses are good this is the problem.
unsolder and, replace the relay.
57h93 clicks only when i
Hello,
your TV is having a power problem. Its receiving power but
it cannot transfer the current to the necessary part because a
capacitor, diode, etc but have been faulty. Until these bad components
are replaced, the TV might not come on.
If you know about TV
repairers, I would suggest that you open the TV and read the power
part/panel with a meter, detect the bad component and replace it. Take
note that TV stores a lot of current that can shock, so leave the TV for
a while before you open it.
If you don't know about TV
repairers, take the TV to the nearest repairman to fix the fault for
you.
I wish you good luck.
How to replace power supply?
Toshiba model 57H93 worked perfectly last night. Turned off and went to bed. Turned on this morning, and nothing, it won't turn on. Checked all cords and cables, pushed reset button, and still won't turn on. What could cause this to happen?
No power
has a short in the power supply I suggest it is a technical revs
How to change a fuse on toshiba 5793 when a power surge occurs
hello yes there are fuses. the main one is located in the power supply it glass type it might be black where it has shorted if you replace it and it blows again then you have a dead short in the power supply good luck. ps on the main there are wickman fuses these are solder in to the board
shaun
After power surge my tv
after a power surge if you dont have in on a surge protector it probably fried the main board in the tv so it wont work anymore..woudl probably be cheaper to buy a new tv than to try to repair the one you have now
57H93 Toshiba
Protect screen Part # 23311038.......117.30
Fresnel screen ( inside ) # 23311014 ...65.47
Lenticular screen ( middle) # 23311128....81.96
You should only need the protector screen......T.
Toshiba 42RV500E sound issue
This is a known issue with this TV. The following might resolve it:
Check Mute and Volume:
Ensure that the TV is not muted and that the volume is set appropriately. Sometimes accidental button presses can lead to muted sound or low volume.
Inspect External Speakers:
If you're using external speakers, verify their connections. Loose cables or faulty speakers can cause sound issues.
Test Different Inputs:
Connect a non-HDMI device (such as a DVD player) to the TV. Observe if the sound distortion occurs. If it doesn't, the problem might be related to the HDMI signal from your Virgin box.
HDMI Troubleshooting:
If the issue persists with the DVD player over HDMI, consider the following:
HDMI Cable: Check the HDMI cable for damage or loose connections.
Virgin Signal: Contact Virgin to inspect the signal/lines and replace the box if necessary.
Mainboard Replacement (if needed):
If the sound distortion persists, it could be due to a faulty sound processor chip on the TV's mainboard. In this case, consider replacing the mainboard.
TOSHIBA 42RV500E, 42RV500T, 42RV500Y, 46RV500E, 46RV500T User Guide (manualmachine.com)
4/6/2024 12:18:57 AM •
Toshiba...
•
21 views • 0 helpful votes
Not finding what you are looking for?