20 Most Recent
Ricoh Aficio SP 9100DN Laser Printer Monochrome - 75 ppm Mono - USB - Fast Ethernet - Mac, PC - Page 3 Questions & Answers
Solve error code sc360 aficio mp4000
When you replace developer, make sure to clean the waste toner path on the PCU. Waste toner in combination with new developer causes trouble. After replacement of the developer use a piece of paper to block waste toner from falling into the DV-Unit. Then run SP2-801 and do process control.
Then make 100 copies and after that remove the piece of paper. A Ricoh tech told me that the amount of toner in the developer can be very high, so he always made 100 copies before removing the piece of paper. I'm doing this for a long time and I never had trouble with SC's related to TD-sensor.
How i reset maintenance on ricoh aficio sp 4310n
The machine will automatically reset the maintenance message when the fuser is replaced.
There is a looped wire on the fusing unit connector containing a thermo fuse (a thin wire that quicly melts, and then short the cirquit).
If you don't want to replace the fuser yet, you can probably set the machine to meter charge, SP mode 5930, and then reset the maintenance counter with SP mode 7804.
You can of course take out the fuser, and replace it with a dirt cheap thermo fuse bought from Ebay. Then set the fuser back into the printer, and it will clear the maintenance message automatically.
Either way should work fine, at least it used to do that on the previous model - and it is almost identical.
Tristan
try saving document to desktop then print it. Sometimes there is info in pdf you don't see. I have had customers that have this type problem and after they save it prints just fine.
Richo afico 5002 code sc 878
1. Improper firmware update.
2. SD Card size greater than 2 GB used.
3. Multiple ROM data folders in SD Card.
4. Improper Java firmware update.
5. Power failure during firmware update.
6. Power line issues on the outlet.
Replacement of the Controller Board is necessary in case SC Code 878 occurs.
Ricoh aficio c420dn wont print black
Hi, my experience with this machine is that the gear that drives the black pcu breaks or cracks. Usually caused by the pcu being too hard to turn. I always turn the developer gear in the pcu before installing it just to loosen the toner.
Ricoh sp811dn toner cartridge is ot detected when replaced
In the back of the machine on the nozzle assembly there is a toner end sensor. It is possible it just needs blowing off clean. Excess toner spillage in that spot prevents the sensor reading correctly. However, if that do not work, it may need new sensor.
Not finding what you are looking for?