20 Most Recent
Ricoh Aficio SP 9100DN Laser Printer Monochrome - 75 ppm Mono - USB - Fast Ethernet - Mac, PC - Page 5 Questions & Answers
RICOH Aficio 3045 Necessary HELP!!! Necessary
If you go into "user tools" is there a printer and scanner option there? If not the MFD does not have the print option.... If it does you need to program the IP address sub net and gateway. -Carl
RICOH Aficio 3045 HELP!!! Necessary
If you have used various computers with different OS's and you still cannot get any to recognize the printer, then it would appear that the printer electronics are fubar.
U might check with Ricoh but ......................
Ricoh aficio 1800 .why copies are now black lines appear from top to bottom?
I guess you talk about Ricoh MP 1800.
The Black lines on the bottom appear because the copier has made more than 60,000 prints or more if new.
If it's bought used, than it has made 60,000 or more prints from the last change of the drum and the drum cleaning blade. For the print to be clean again, it will need to be changed the drum and drum cleaning blade. This copier as all other copiers have parts that have a yield.
MPC305spf cannot login
Doesn't http://www.fixya.com/support/t16807144-set_ricoh_aficio_mp_c305spf_factory help?
Error sc300 on Ricoh mpc 7500. i replaced the drum unit and its fine but after two weeks the error came up again
The error code you gave shows several possibilities for your issue:
Drum charge corona wire, The output of the charge corona wire of the black PCU is abnormal.
Causes
• CGB power pack connection loose, broken defective • Check CGB power pack connection to BCU • CGB power pack defective • BCU defective • Replace OPC drum
Of the five possibilities above, replacing the drum is the most likely cause. Since you only had your drum for a couple of weeks I would take it back to where you purchased it and ask for replacement. Sometimes you get a bad drum out of the box from the manufacturer. It happens. If the same error code pops up again, I recommend you call your local Ricoh dealer for further troubleshooting.
Firmware updade
Firmware can only be downloaded by someone with "My Ricoh" access. If you have the Firmware or you are able to get it, just create a "romdata" folder on a SD card and dump the .fwu file in the "romdata" folder. Switch your machine off and insert the SD card into slot 2 on the machine controller. Start machine up and select the firmware you want to update. Machine will reboot when its done. If it doesn't than switch the machine off and remove the SD card and power machine up again. Now you are done.
Error code sc650. how to solve it?
Your Duplex unit is not connected properly. Check the connector and ensure it is all the way in. Also check your Document Feeder connector while you at it.
Not finding what you are looking for?