20 Most Recent Pioneer DEH-P440 CD Player - Page 8 Questions & Answers

You can't directly plug in the Aux cable. The mini-plug for the AVH-285 is on the back of the receiver but it handles both audio and video from a composite source. (Note: this position means that it isn't easily reached when from the passenger compartment.) You do need the CD-RM10 composite A/V to mini-plug adapter. The mini-plug port is between the video output and the rear/subwoofer outputs on the receiver. See page 35 of the manual for the picture. If your Aux input device has a 3.5 mm audio out (headphone jack), you'll also need a 3.5 mm (F) to RCA (M/M) adapter. Pioneer has the manual for the AVH-285BT on the product page: https://pioneer-mea.com/en/products/avh-285bt/ . Two current link to the manual is http://pioneer-mea.com/wp-content/uploads/2015/12/AVH-185DVD285BT.compressed.pdf and https://www.pioneer.com.au/wp-content/uploads/2016/10/AVH285BT-Instruction-Manual.pdf . I hope this helps. Cindy Wells

Try to burn a CD not a dvd

Yellow wire (constant or memory) needs hooked up to a constant hot wire.

Check out the ground wire , make sure it's attached to bare metal on frame of vehicle.

in that case, go to setting and fine the time and date to set a correct date in your pioneer

go to settings and change it there , Japan word for english is ?? hope this helps.

YOU HAVE ALLOW PHONE BOOK ACCESS FROM THE SETTING AND IT WILL WORK

CHECK THE BACK OF THE UNIT IF THERE IS A MIC PLUG YOU HAVE TO GET A PIONEER MIC AND IT SHOULD WORK

Hello Laurie, I sent you the link to download the user manual of your Pioneer DEHP49001B I hope you can solve your concern Greetings Franco Dosi Hola Laurie, te envio el link para que descargues el manual de usuario de tu Pioneer DEHP49001B Espero que puedas resolver tu inquietud Saludos Franco Dosil https://pioneerelectronics.com/StaticFiles/Manuals/Car/DEH-P4900IB_OM.pdf

Real Answer to set Clock on Pioneer DEH-6 AM/FM/CD car player - DEH-6 will have no FUNCTION button. 1-Press SOURCE ("SRC" - button left of "1") and hold until unit powers off. 2-Press AUDIO ("A" - button upper right) and hold until clock appears in display. 3-Press </> arrows to select hour/minute to set - numbers will blink. 4-Press up/down arrows to increase/decrease hour/minute. 5-Press "BAND" or press "AUDIO" ("A") until unit powers off. 6-To check: Press CLOCK to turn on new clock setting display.

Try to reset it . source ,, it is looking for a source such as CD player radio USB.

I would contact Pioneer they need updates right away i did a lot of searching and asked fellow bass audio friends and they dont know anything of it either must be an older unit.

Mosfet 50wx4 indicates a feature of the Pioneer car radio. It isn't a model number. One Pioneer car radio/CD player with this feature is the DEH-1500. On this model, you need to turn off the unit to set the clock. Press and hold the Source button (to the left of the preset tuning buttons) until the device turns off. Press Audio (upper right corner) repeatedly until the clock appears in the display. Use the arrow keys (Skip/Back or Left/Right) on the right hand side of the radio to select a segment of the time to adjust. Use the Up/Down arrows to set the current time. Repeat choosing the time segment and adjusting the time until both the hour and minutes are correct. Press Band or press and hold the Audio button to exit the clock setting mode. ManualsLib has the manual for the Pioneer DEH-1500 here: https://www.manualslib.com/products/Pioneer-Deh-1500-Car-Cd-Player-Mosfet-50wx4-Super-Tuner-3-Am-Fm-Radio-3432555.html . See page 16 for the clock setting procedure: https://www.manualslib.com/manual/129844/Pioneer-Deh-1500.html?page=16#manual . See page 6 for the picture of the front-panel buttons for the DEH-1500. I hope this helps. Please add a comment with the model of the car radio if the above procedure doesn't work for your unit. Cindy Wells

Are they dual voice coil? Are they dual 2 or dual 4 ohm? If d2 you willnot be able to run both off that amp at 1 ohm you can run 1 at 1 ohm if d4 then parallel the voice coils and the subs together to get 1 ohm.

take battery out and hold power button down for 10 sec,then wait 30 sec put battery back in,let me know

Is this the harness you are using....Metra 70-1771 Radio Wiring Harness for Ford/Lincoln/Mazda 1998-Up into Car, 16 Pin
https://www.amazon.com/dp/B0002BEWZQ/ref=cm_sw_r_cp_apa_i_HzCTCbPS1C6D7

This could signal that your battery is not able to power all the equipment. Have you considered getting another battery? For this and more tips, kindly see link http://electronics.co.ke/

I know mine resets everytime i disconnect my battery i lose all my settings

The wiring harness diagram for connecting the AVH-X2500BT receiver to the car wiring is shown on page 46 of the owner's manual. Crutchfield has the manual on the product page: https://www.crutchfield.com/S-KZq3UpLmFAw/p_130X2500BT/Pioneer-AVH-X2500BT.html . Look on the right hand side of the page on the Overview tab. The link is below the "What's in the box" header. The direct link to the manual is currently here: https://pdf.crutchfieldonline.com/ImageBank/v20130710152000/Manuals/130/130X2500BT.PDF . You can also find the manual from Pioneer on the archived receiver manual page: https://www.pioneerelectronics.ca/POCEN/Car/ch.DVD-Receivers.Archived . I hope this helps. Cindy Wells