20 Most Recent
Samsung HCN4226W 42" Rear Projection HDTV-Ready Television - Page 7 Questions & Answers
Television won't turn on at all
Sounds like a power supply problem. If you know how to test solid state componets and make voltage measurements. Get a schematic and conferm the power supply is bad and go to this link for your samaung parts.http://www.samsungparts.com/search/search.asp?searchflag=byonemodel&searchkey=HLR5656W&modelid=379072 Good Luck
Please dont forget to rate this post.
No sound or picture on tv
Unplug power, open the lamp door, take out the bulb and put it back in place, plug back and restart, if it does not start there may be an additional fault.
How do I do a factory reset?
With the tv off, press on the remote Mute,1,8,2,Power
This enters the service menu.
The factory reset option is in there.
TOSHIBA TV- HCN4226W convergence PROBLEM
I charge 285.00 at my shop ,so if you cannot fix it your self you are looking at repair anywhere from that price or more .You have 2 STK ics these are your convergence Chips .You would need to replace both of them.If you can solder you have it made.
Bowing screen
You have bad convergence ic's. You can take the convergence board out yourself and take the part to a repair man to have him replace the ic's. I've had it done twice on my tv, it cost about 200 bucks.
Tv appears to be getting power
Most of the Time STKs need to be replaced 2 of them STK392-110s ,they are big black ICs order parts on line or call 1-800-223-3205 or 1-800-628-1118. Also Ck all low ohm resistor around ICs 2.7 ohms usually there is 2 of them bad.
HCN4226WXIXAA
Good be just about anything. This set is common for the regulator IC, the STR-X6456 regulator IC to go bad for starters, the flyback transformer goes bad and takes out the horizontal output transistor sometimes and then blows the main 10 amp fuse. I have also seen the convergence IC's go bad then the set dies because the main fuse blows out, the power supply will go bad because of a surge. If you have no TV repair knowledge, play it safe and have the set looked at by a pro. Good Luck
Tv issue
I have the same problem was there a solution to the problem
Insignia TV and Direct TV
The TV slowly, all by itself, ran closed caption on the major stations.
Unable to turn off through the menu as that option was greyed out.
Now all channels have this unwanted closed caption.
Any similar problems and ideas.
Thanks, Harold
Sony KDF-E50A10 Green picture.
For BnrMan213,
I believe your issue with Light engine.(KDf-E50A10) If you have warranty on this unit contact seller.
Good luck
Dals123.
Same unit different problem
Customer replaced Lamp ***'y still unit bliks, there is two reason.
1.if your lamp door not closed properli it will blink.
2.watch for ballast ***"y fires the triger to on the Lamp? if not your old lamp is good repalce Ballast..
Good Luck
Dals123
Not finding what you are looking for?