20 Most Recent
RCA D52W20 52" Rear Projection HDTV-Ready Television - Page 4 Questions & Answers
Picture gone with sound
you might want to check the lamp housing there should be a screen on it that allows the fan to cool the lamp very carefully clean the screen
Dvi hdmi
Some more information is needed on what you are trying to do.
Usually you can buy a HDMI to DVI cable to do the job. This may also be referred to as a PC to monitor cable.
This image may help in identifying what type of connector you have...
Power won't go on
From what I read if the power light flashes and the tv doesn't come on it has a bad bulb.
Got sound but no picture
Try removing your projector bulb and cleaning the screen between the fan and the lamp it may be overheating due to lack of cooling air causing lamp to not illuminate hope this works for you , it has for me on two occasions p.s be careful not to touch the bulb with your fingers
The tv wont come on at all no green light no
My be fuse on power supply board but also the 5 volt run my be down.When you plug in the set this voltage is there to run the processor . Check the voltage at the remote control senor there should be 5 or so on that small board.
Green LED flashes three times, wont turn on.
Most common cause for this error on this model is bad Capacitors on one of the Boards, you will be looking for Capacitors that have a Swollen Top are bad and need to be replaced.
I have a RCA 52 inch HDTV model D52W20B when you
On Deflection board CK capacitors cp150 2200uf 16v if it is puffed up on top it is bad their is 2 more caps in same circuit replace them also cp114 cp120 220uf 35v also resolder all pins on FBT flyback Transfomer
Not finding what you are looking for?