20 Most Recent Broksonic CTVG-5463GVC 19" TV - Page 6 Questions & Answers

Hola, posiblemente el circuito integrado donde se realiza la seleccion de audio sea el problema y no el amplificador de audio ya que funciona con el DVD, habria que determinar cual IC realiza esta funcion tomando como referencia la salida demodulada de audio desde la etapa de frecuencia intermedia o adonde convergen todas las entradas de audio del TV.

Hi,

I have requested a copy of the manual and will upload it for you as soon as it is received. However, there is no guarantee that my request will be answered.

If you would like to request the manual yourself, please complete the simple form at the Hatzlachh / Broksonic website:

http://www.broksonic.com/ContactBroksonic.asp

Unfortunately, this manual is not currently available online - but with any luck it soon will be.

Regards,
BElectric

Testing remote control: The remote control puts out IR (InfraRed) signal that human eyes cannot see, to find out if the remote is sending out the signal or not you just point the remote at the digital camera's Lens (Digital Camera can detect IR), you should see flashing light on the camera's screen when any one of the remote button is pushed. If you do see the flashing on the camera, then the problem is in the TV IR receiver or the main logic board; more troubleshooting with scope will be needed to look at the signals. Parts: www.shopjimmy.com www.remotes.com

Basic LCD monitor troubleshooting guide: http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague

Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you.

are you using bootleg dvds?some players will not play them.if this is not the case maybe something is wrong with your dvd

Hi.

If the problem is restricted to two channels only, and the rest of the stations are working, then it can be a faulty tuner device. If you are using an external tuner box, test using a replacement tuner.
If you are using the built in tuner (aerial connected straight to coax socket at the back of TV), then the problem may be the internal tuner.

Before contacting repair or purchasing part, ensure that the problem is not low signal (bad reception). Video and audio digital signals are carried on different channels.

Test the TV performing a channel tuning and resetting to factory settings.

In some case the problem may also be caused by connection used. If for example the sound is carried from a receiver to the TV through RCA cables (red and white), you may have no sound from some digital channel. If the TV uses an external receiver box, test using different kinds of connection.

just through it away and get a new one

probably its finely out of tune, i would get onto settings then manually tune it myself. or if this fails.. call your service provider. its nothing that you have done wrong. its them. also. at the back of your television. make sure ALL essential leads are fully plugged in..

i found a remote at 1-800-remotes for $25.81 plus shipping

if you call your tv provider and tell them your problem they will have someone over there to fix it in 5 bisness days

Hi,

First try adjusting the tint value under the picture settings menu. If this does not have the desired effect try this to enter the service menu - (sequence is model dependant) using the remote control enter the sequence MUTE, TIMER, PICTURE.
Service menu should now appear on screen - use UP & Down buttons to select the relevant item for adjustment.

If these solutions fail to work you can request this information directly from Broksonic under their Support and Troubleshooting Tab at this link
http://www.broksonic.com/

Hope this helps. Please do rate my answer. Many Thanks.

sounds like there is a storm inside the set..!!!

the EHT connector is tracking to ground or the loptx is leaking and sometimes there is a smell when this happens.

i would not advise you to tackle this fault unless experienced at repairing tv's
as if you dont discharge the tube safely it may discharge through you !!!

but if you feel confident on doing this then take back off tv and in a dark room you maybe able to see the arc where its tracking.then its a case of replacing EHT cap , lead or even worse the loptx

but before you remove the EHT cap make sure that you discharge the tube to ground BEFORE removing it as crt tubes can remain charged for some time even days after the set has been switched off. 25kv jumping through your fingers is not nice.

best of luck.

It's not the screen, it's the inverter that drives the backlight.

This is a box for text, such as closed captioning or demonstration mode. Go into your setup menu and turn off closed captioning or return to factory settings.

Sorry, but we do not supply parts. This is a website for advice on repairing items. You could try contacting the store you bought it from or contacting iheater directly.

Sorry, we do not supply anything. I would aproach the supplier or manufacture for advice and spares availability.

It appears that there could be miscommunication. As of my previous update in January 2022, Matertech doesn't seem to be a commonly known term or corporation. On the other hand, if you're talking about "Google," it's a well-known worldwide technological corporation that specializes in internet-related services and goods, such as search engines, cloud computing, online advertising technologies, software, and hardware. Google's official website or an internet search utilizing one of the search engines like Google itself are usually the easiest ways to get information about Google. If "Matertech" relates to a particular thing or idea, further information could be helpful in order to provide a more precise answer.

Refer its user manual for details.

Put the batteries back in and aim the front ot the remote at the front facing selfie camera on a smartphone. Press a button and you should see a flash. If no flash, the remote has failed. If there is a flash, the television IR module or main board has failed.

Telefunken Replacement TV Remote TLED-26FHDPA

Soundtech https://soundtech.co.za > telefunken-replacement-tv-rem... Telefunken replacement remote compatible with TV models: TLCD-29FHDP TLCD-32FHDA TLCD-32HDA TLCD-37FDHA TLCD-37FHDA TLCD-39FHDP TLCD-40FHDC TLED-26FHDPA ZAR 199.00 ..

Question edited for a lot more clarity, full 'make model (what it is)'. There is more to this that meets the eye because your set is analogue and the new cable box is digital. Have a read

Is it possible to modify my kitchen Venturer KLV39103C tv in

JustAnswer https://www.justanswer.com > TV Problems Jun 9, 2021 - Your TV has only one external input and it's an analog coaxial input, hence why the converter and modulator will be needed. 1 answer · Top answer: You are very welcome. In my opinion, it would be much simpler to simply j More here https://www.google.com/search?q=venturer+klv39103+convert+to+digital ..