20 Most Recent Roland Cube-st Battery Powered Amp Cube Street Cubest - Page 6 Questions & Answers

Will probably need to be diassembled and cleaned. Either a sticking key or a compromised contact on the circuit board. Any electronics repair shop should be able to fix this.

You need to replace the battery. It will most likely be a coin sized battery in a slip in holder on the main board. If you need help, here is ROland Customer Service contact info- Support Roland After that, you can reset the E96 back to the factory settings by following the directions here- Roland 96 Initializing the 70 86 96 Restoring the Factory Settings...

This problem will require servicing. The screen is bad, and has to be replaced.

if your saying the power goes on/off allot then its got to be your power cord or connector in the back , these do have a hard life as these get moved around a bit , its gonna take a pro repair to replace the power connector-but you can buy new cords for them , try to wiggle it to confirm that's it , but if your display just goes on off , this is a software problem as most likely a error in reading the drive

Squeaky usually means something needs oiling. If you have a long snout on an oil can, you may be able to reach the pivot on the pedal to oil it. If not, then you have to take the pedal apart to oil it

It sounds like the jack on the unit which you plug the high hat into is defective if it works on the other unit.

Contact Roland in whatever country you're in for the service centers in your area. For instance in the USA check this link- Roland Support Service Repair Service Center Locator

Contact Roland directly. Speak to their customer service department in your country. I beleive this is the info- http://www.dealerlocations.in/roland-dealers-in-kolkata If it's just a parts availablitiy problem, remember that Roland is a world wide company. Contact Roland in other markets, starting close to you and expanding out. Somebody will have it. I'm in the USA and often source parts from Canada, for instance. If the instrument is truely dead, you can always sell it for parts to other users. Ebay would be a good option.

That sounds like a compnent failed in the preamp section. This will not be user servicable and will need to go into the repair shop.

Support Roland Your best bet is to contact Roland support. Here's the link- Support Roland

if its less than five years old then you maybe able to order it right from roland , older than that you can always ask them but you might be out of luck , a friend of mine had a problem with his keyboards display too and it turns out it had a external display monitor output on the back, ive rigged him up a small 4 inch tv that plugs right into it and now he can select all his functions using that . works

As far as I know, Roland programs all it's drum sounds in all of it's instruments from the factory to the same note numbers.

As long as your power supply is supplying the correct voltage and the amp rating is sufficent, and of course the power supply itself is functioning, then your problem is more likely to be a routing error somewhere.. it's probavbly best to center all controls, disengage all switches, and start over from nothing. You should also check that what ever you are using to hear the signal is functioning correctly as well.

Assuming you have checked the fuses, it's most likely the power supply. It will need to go to the shop.

How can you state power supply is working excellent, please?