20 Most Recent SWANN Adw-400 Video Surveillance System Sw344-dwd - Page 7 Questions & Answers

yellow is the video red is the audio plug them into the tv

Find the model number, then Google search for a manual. Serial numbers are of no use when troubleshooting electronics.

try to change the battery on board

A swann N3960

1) Turn the power off. 2) Remove the printer cover. 3) Remove the ink roller by turning it counterclockwise and pulling it upward. 4) Install the new ink roller and press it in the correct position. Make sure that the ink roller is securely in place. 5) Put back the printer cover

Hey there! You must have the Video card with the receptors for the TV, which is normally to the front or the back of the TV; of course the ability to turn the channel to input 1 or 2 as the case maybe. You must also have the power adapter for the camera, plus the BNC adapter from RCA to BNC. The computer needs a PCI video card, with similar fittings. Tha's it.

Hi Rod They don't seem to have wiring diagrams or schematics for the public any more. It's a throw away world! Contact Swann support Tech Support Email

Those cameras use infrared led lights to see at night. If you have no image at night then those led lights are not working.

try removing battery

Go to hidden icons on the taskbar and click the my dvr icon.

I would guess that you would hook it up to the internet source and find the IP you are given or assign yourself one. Then it is oossible to look at that IP address to see what is on the NVR

Most likely the center pin is grounding out. Have you opened the box yet? If not open it an try to solder it back on. Better yet just replace the whole BNC. How did you break a BNC? They are common parts, just get the correct impedence an the correct chassis mount. Becareful desolding the unit an dont over heat replacing it.

You need a HDMI monitor to hook up a CCTV camera not a TV.

replace monitor, your DVR video display resolution is higher than the monitor capabilities.

Well it might help if you actually said what you needed help with regarding swann equipment.

what is the model of the cam? some cams only do video depends what its saving the file as may be your software that wont play the audio but plays the video ok check the codec used to save the audio

What DVR system are you using? Are they connected to the back of the DVR properly? Check your connections at the DVR. if your DVR system came with a mouse, right-click on the screen choose the icon with multiple screens, and then if you want them to alternate, click on "start tour".

Check your power cord connections if there are any splices check those BNC connectors, check at the back of your DVR, make sure that they are connected good and tight. Is the AC adapter plugged in, is it tight in the outlet receptacle? Check your video cables as well at the camera, any splices, and again the back of the DVR.

Amazon com Adw400 ac adaptor Convert BNC to VGA or HDMI with Sewell check out the above links, it might be what you're looking for?

1. Contact Swann, they have a very helpful support team.
2. They have software that makes remote viewing so easy.
3. Have your serial number for your DVR available, provide it to them and they will walk you through downloading the software and assisting you with the set up. It doesn't matter when you purchased it, they are very helpful.
4. And if you would like, with your permission, they will take control of your computer and do it for you!
5. Absolutely helpful team.

1. Swann Communications Portal