Top 20
Fender ® Frontman 10G Electric Guitar Amplifier Questions & Answers
Input
Remove the old one and go to any Radio Shacks,they will have the replacement,also I stress this soooo MUCH,MAKE SURE ITS UNPLUGGED PLEASE....TY
6/12/2014 10:18:02 PM •
Fender ®...
•
134 views • 1 helpful votes
Hi. Fender Frontman amp suddenly
This is a very simple unit: a power source of an linear design, a preamplifier with tone and distort control and an 10 watt integrated amplifier.
If the unit is completely dead then the fault is in the power section: cable, switch or source. To find out which you must check them all with a simple multimeter: cable and switch with an ohmmeter (the resistance should be 0 if good) and the source with a voltmeter - (check the presence of the 2 voltages (25 and 15 volt) at its outputs.
Here you can find the schematic of a very similar one
http://www.schematicx.com/view-schematic/fender-frontman-15g-15r-guitar-amplifier-schematic/
The only difference is the final amplifier chip.
5/28/2011 8:11:38 AM •
Fender ®...
•
954 views • 1 helpful votes
If I turn up the
You MAY be overdriving the amp. This is a tiny amp and should NOT be played louder than a typical BoomBox or the speaker may be driven too hard, going non-linear and then buzzing.
3/19/2011 6:54:31 PM •
Fender ®...
•
444 views • 0 helpful votes
Just a loud hum when turned on.
Hum is always connected with the presence of AC interference into the signal path of the amplifier, which means the audio amplification is mixed with the ac ripples.
So this can be a break down with the power supply as a possible tank capacitor or a stabilizing capacitor in the main power or the sub sections of the amplifier or pre- amplifier.
2/11/2011 11:07:56 AM •
Fender ®...
•
419 views • 3 helpful votes
Guitar amp input not working
Get inside it and check the connections to the plug especially any shielding / braiding. Resolder the connections.
4/17/2022 3:36:38 PM •
Fender Music
•
122 views • 0 helpful votes
How does a fender ax-12 chromatic tuner work
I'm an engineer, not a musician. The device is a frequency meter set up to display the musical note input to it. If you pluck a C flat and it shows an A you need to tune your instrument till it shows a C flat. You will have to refer to the manual for operation and modes.
12/4/2019 4:47:04 AM •
Fender Music
•
188 views • 0 helpful votes
Not finding what you are looking for?