20 Most Recent
Fuji FinePix S304 Digital Camera - Page 5 Questions & Answers
Finepix a600 not recognized
Remove the camera software entirely.
Assuming you PC is 2000/XP no camera software or driver is required.
It should simply come up as a new drive in My Computer
Come back on this one
Black screen when camara is in photo mode
anyone else had this? or know what to do.
whatever best you can do is to take the camera to a good repairer as you can't fix the problem by yourself. there may be two possible reasons for the problem. 1) bad image sensor i.e. damaged CCD or 2)shutter blade are not working. the shutter blades may be jammed due to friction are no signal.
Camera works with comp but not with batteries
Leave the battery out for at least an hour. The camera will return
to default settings when the "memory" is cleared after the reserve
power in the camera runs down.
When you put the battery back in you'll be asked to set the time/date again. It'll also revert to 1MP so you'll need to change your settings too.
if it doesnt help, send it to repair - it looks like a switch malfunctioning...
Transfer Problem
What did your PC screen say? It is the PC that does the file transfer not the camera. If you use a Window XP OS, a window on the PC screen should pop up and ask you what you want to do. If you don't see that (plug and unplug the USB cable again and/or use your window window explorer (right click on the start icon and choose explore) to look for your camera. I don't have a Finepix S304, may be the camera screen just telling you that it detected a PC hook up to the camera.
Good luck, Hope this help.
Focus error finepix hs10
About the HS10 autofocus problem, I discovered the cause and solution. It is a problem of camera design, and is caused by three screws securing the CCD sensor. These screws are not properly secured and the vibration eventually dropping.
In two cameras with the same defect, the screws were loose. These screws adjust the sensor position relative to the lens and the sensor is loose when out of position not allowing proper focus.
The solution is to disassemble the camera and secure the screws.
These screws can not be too tight they need to be adjusted to position the CCD sensor correctly. The camera is difficult to dismantle because several wires are soldered.
Care must be taken to discharge the capacitor of the flash, this may cause an electric shock and burn the camera board.
Those who want to try the repair, follow the link to the service manual.
http://elektrotanya.com/fujifilm_finepix_hs10_hs11_sm.pdf/download.html
Milton Maenishi
I have a FinePix S1 and the display screen is not working. All other modes are working but no display
Many occasions LCD on camera display never fails but back light fails unless physical damage to LCD screen. Hold a torch to display when camera is on you will see faint(black and white) image means LCD is ok but back light is failed, it's replaceable but needs little skill to replace. Or replace full Screen with backlight. This is easy. Just remove back cover, remove display by loosening flex lock, put back new display carefully lock it holding flex with one finger. Please do not touch display flex contacts.
Lens will not retract. Powering up ok.
Pull and twist gently to see if that will dislodge whatever is keeping the lens from retracting. You may have gotten some dirt or sand in the mechanism. It doesn't take much to prevent retraction. If it is dirty, a little gentle action will sometimes free it.
Not finding what you are looking for?