20 Most Recent
Sony MegaStorage CDP-CX355 300-Disc CD Changer - Page 3 Questions & Answers
CD Changer won't finish loading a CD
I had the same problem and found the cure for it. The drive belt was streched and when it started to close on the disc, the belt would slip and eventually show loading error..The two belts cost $4.50 at belts plus. Hope this helps you
Carousel will not turn
Could be a broken/loose carousel belt. take the cover off and look near the back of the unit and make sure that both belts are on there respective pulleys.
Carousel isn't turning any more
Hi,the problem with your carousel is the server unit which powers the output IC,it needs replacement,however,this problem is a very technical issue that requires highly skilled technique and caution,i understand you are mechanically inclined,but i strictly forbid you from doing this yourself because you might end up blowung up the y board on your device.
In conclusion.i will advice you seek the assistance of a qualified technician in your area to help you fix your carousel.
Thanks and take care
It's not the optical cable
The presence of light is not proof of the presence of data (music, in this case).
There has to be another unmentioned piece to this puzzle - like a receiver. Is IT configured to use that optical signal? It's PCM, by the way, not mutichannel or Dolby Digital as the Bluray might be.
Sony MegaStorage CDP-CX355 300-Disc CD Changer
Hello,
how long have you been using this player? I suspect the laser (lens) of the player. I think the laser (lens) is weak that's why it is refusing to play any more CD....
Get a lens cleaner, use it to clean the lens. If that doesn't solve the problem, get a screw driver, open the player's cover so that you can gain access to the lens, use a cotton board to clean the surface of the lens. This should clean dust or dirt that might be on the lens. You can add very little liquid to the cotton board like mentholated spirit and dry the lens with another cotton board that has not liquid on it.
If non of the above solves the problem, then it means the lens is weak beyond cleaning. Know that you need to replace the laser to a brand new one.
To replace the lens, remove the bad laser, use it as a sample to get exactly the same type and do the replacement. Note that replacing a laser (lens) needs a professional touch, so if you cannot replace the laser, get it to a repairman to fix it for you.
Once this us done, your player will play all CD's again without any problems.
I hope you understand the above.
Regards.
Sonny Mega Storage 300 cd,
will you please state clearly on what is the problem of your device so I can give you the correct information..thank you and please post back.
When power up table spin both directions theb
the sensor for the table cna't read the table movement. it's an optic sensor and it might be dirty or obstructed. you can open up the unit and blow out any dust with canned air. check the sensor for damage.
Shuffle led jus spins and
Try cleaning out the compartment with compressed air. There could be dust or dirt blocking the beam.
Not finding what you are looking for?