20 Most Recent
Sony Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television - Page 3 Questions & Answers
I have a 55" Sony Wega HDTV rear projection
You should do a regular cleaning maintenance to the air filter and exchange it regularly. Small dust particules may get into the internal projection module and those spots became visible.
White spots on DLP TV
If your TV is less then a year old, I would suggest to call the manufacturers and ask them for an authorized service center to get it fixed.
If that is not possible, the spots could only come from the light itself. I would suggest to check the light for some dust or any other particles that could be blocking the light source. The light may also have that contamination internally, if that is your case the light will need to be replace or you can leave it that way until is time to change the light.
Let me know if you need further assistance.
Sony Wega KF-42E200A Projection Bulb
New bulb is just fine.
3 blink shows that lamp cover after replacement of bulb in TV is not fixed properly or not seated well in its position.
Put new bulb and carefully place back lamp cover in its position because lamp cover will press tinny safety switch inside that will send signal to system control of TV that lamp is installed properly.
Turn On TV and get vivid picture of Sony.
Thanks.
Sony restarts frequently
I am experiencing a similar problem.Any assistance you can provide is appreciated.Please advise whether your problem was resolved, and if so, how?
Blinking 4 times red .... can u help? sony wega.
There are a number of forums that deal with the error codes for this and other models---if you want to find the answer for yourself Google the full model number with "4 blinks" or "error codes" and if you cannot find the answer leave me a note here and I will research it and find out.Keep in mind the blink code is just a general indication of what is wrong---it does not mean replace part XYZ and set will be working again.
Standby light flashes
the lamp thermal sensor is probably bad...you ma also have a lot of dust around the lamp fan..there is a service kit for this problem.
a1137954a..you must clean all the dust from the fan above the lamp or replace it.
Sony Triniton Wega Model KV
This is usually an indication of a failure in the scan amplifier sections. When the scan amplifiers or high voltage sections fail, the main power supply will usually also require servicing.
It is very common that the fly-back and high voltage multiplier and also the horizontal output stage fails in these sets. Along with it, the power supply will usually require to be serviced. On rare occasions, the vertical deflection amp fails.
Jerry G.
KF-50WE610 will not turn on
GREEN LIGHT IS ON AND IT DOES NOT SHOW PICTURES AND IT 50SOUND IT 50'' 1080 NONY TV IT WAS MOVE FROM ONE PLACE TO AN OTHER WHEN IT STOP WORKING
Not finding what you are looking for?