Sony FD Trinitron WEGA KV-36FS120 36" TV - Page 9 - Answered Questions & Fixed issues
My sony trinitron turns off by itself and then the
Hi,
This is picture tube related problem and we call it incorrect white balance.
Adjust Screen Volts of picture tube and control knob wold be located on flyback transformer. If you have knowledge about tv and know that tv contains high voltage and you can take care of that then do it yourself or ask local tv repairman to fix it.
Thanks.
6/13/2010 12:20:05 AM •
Sony FD...
•
Answered
on Jun 13, 2010
•
2,142 views
No picture
try to check the supply of the heater from the picture tube..check for open resistors..the heater is located at the CRT board it is the board that connected to the picture tube the supply of the heater comes from the plyback...
6/4/2010 3:03:00 PM •
Sony FD...
•
Answered
on Jun 04, 2010
•
107 views
Sony wega 36
power board...count flashes..if any. Call tech support
6/3/2010 8:14:47 PM •
Sony FD...
•
Answered
on Jun 03, 2010
•
88 views
Tv wont turn on red light blinking
Thera are a couple of ics in the power supply of this set known to fail. A shop familiar with sony will be able to fix at a reasonable cost. if you are technical ,I can guide you furhter
6/2/2010 8:20:19 PM •
Sony FD...
•
Answered
on Jun 02, 2010
•
363 views
GETTING MESSAGE TV WILL SHUT OFF SOON ON Sony
More than likely someone has inadvertently set the sleep timer to ON. That will cause the set to shut off, it kindly gives you a warning that it will shut off so your TV is more than likely just fine. Usually it can be turned off using the on screen menu and the remote control.
5/30/2010 6:15:57 PM •
Sony FD...
•
Answered
on May 30, 2010
•
445 views
Stand-by light blinking 7 times, wont turn on
Just a guess but could the be classed as a power save mode?
You could try pressing the stand-by button on the tv for about 10 to 15 seconds and see if it makes any difference.
I'm not sure if it will but I've been having to do the same thing on some NEC monitors I've recently been installing.
Sorry if it doesn't help.
Regards
Mike
5/27/2010 2:03:18 AM •
Sony FD...
•
Answered
on May 27, 2010
•
150 views
Sound but no picture
hello,it's either the connections are not right,but if the connections are in order then it is the I.C or tube that got burnt,so all you need to do is to get it replaced.
please kindly rate the solution if it's helpful,
take care.
5/24/2010 10:24:15 PM •
Sony FD...
•
Answered
on May 24, 2010
•
93 views
Turns on stays on five minutes works great then goes on standby
These tv is famous for high voltage it dead or cold solders to it FBT.The flyback transformer,a big black block of plastic with a red wire with a cap hook to the CRT(tv tube).U know how to solders? Take the tv aparts resolders the FBT.Or tries press the power button on/off couples times,if u get a picture.Don't touch it let it on,for three or four hours.Let the heat from the electricity to Amp up the heat,might solved this problems,without resoldering.
4/21/2010 4:48:23 AM •
Sony FD...
•
Answered
on Apr 21, 2010
•
253 views
Will not turn on.
depends on when u got it if its brand new take it back
4/9/2010 12:18:43 PM •
Sony FD...
•
Answered
on Apr 09, 2010
•
84 views
Sony Wega 32 inch tube TV buzzes when turned on
look likes E H T problem. Watch the rear of the TV. If you find blue arc anywhere, you have to check that component. Take care while handling the E H T side near the picture tube.
Even if the TV is disconnected there me dangerous voltage present in the E H T connecting point of the picture tube body. Take service center help.
4/7/2010 7:07:04 AM •
Sony FD...
•
Answered
on Apr 07, 2010
•
130 views
The TV was working fine and all of a sudden the tv
It's possible a component shorted out, keeping the set from coming on. A fairly common part that goes bad in that model is a diode, D500 on the circuit board, and you may find a capacitor or two that is stressed also. I am assuming the power light does not come on or flash.
4/2/2010 5:30:18 PM •
Sony FD...
•
Answered
on Apr 02, 2010
•
110 views
My Sony trinitron tube Tv 36" seems to be going (its 10 years old
no ....the tube will end up after 20 yrs in 10 yr old sony...
it is worth if u fix it. randomly going black means...horizontal driver trans former is the problem..or any loose contact with the 110 volt supply to that transformer,,or any loose contact with line o/p transformer.. (horizontal driver transformer may be gone
then tv behaves like this) if any other parts gone tv wont come back.... there may be a loose contact call a service pro..
4/2/2010 2:32:44 PM •
Sony FD...
•
Answered
on Apr 02, 2010
•
507 views
TV will not turn on
It is NOT the switch, I am sorry, you have developed a serious fault in your set, so much so that the set has shut down the power supply to prevent a fire or explosion, or both. please remove from power. get this unit looked at by a Sony authorised service center, real important, ask for a free "Quote" before proceeding with any repair.
4/1/2010 12:57:29 AM •
Sony FD...
•
Answered
on Apr 01, 2010
•
98 views
Not finding what you are looking for?