Panasonic PT-50LC13 50" Rear Projection HDTV - Page 7 - Answered Questions & Fixed issues
How do i reeet the hour meter
Here is a link to replacing the lamp and the instructions for resetting the timer.
Just search for your set on the page.
I hope that this helps you.
asnowman
http://911phone.net/Panasonic_TY-LA1000_Instruction_Manual%5B2%5D.pdf
6/21/2010 11:13:47 PM •
Panasonic...
•
Answered
on Jun 21, 2010
•
120 views
Red lamp
If it is a new bulb and does not come right on you need to take the platis housing off of the old bulb and put the new bulb in the old housing, the new bulbs dont always fit just right
6/8/2010 9:33:09 PM •
Panasonic...
•
Answered
on Jun 08, 2010
•
106 views
Need to reset the lamp timer
1 turn tv on
2 press vol- on tv and pip on remote at the same time for more than 5 sec a message will appear
5/6/2010 11:48:59 PM •
Panasonic...
•
Answered
on May 06, 2010
•
433 views
How to reset lamp hours?
you can simply go to the tv sets menu and go to lamp hours and highlight it then highlight reset and press enter
5/4/2010 10:07:27 PM •
Panasonic...
•
Answered
on May 04, 2010
•
152 views
My 50 inch panasonic lcd projection keeps going to
check to insure that your input signal is clean,(clean picture) most modern TV`s blank the video if it is deemed of poor quality, also if you are using a VCR and are viewing pirate copy tapes the VCR will output a varying video level output signal to deter pirating of movies, using a video stabilizer between your VCR and your video input may solve this problem for you, check with your user manual as to the light flashing condition in the diagnostic section this will indicate the fault you are experiencing good luck
4/27/2010 9:17:06 PM •
Panasonic...
•
Answered
on Apr 27, 2010
•
213 views
My tv just told me to clean the air filer, what
It means just that. Clean your air filter but to get to it is a different story. I would highly recommend calling an authorized service center to do it.. While he's at it, inquire about getting a ballast kit installed.
4/24/2010 3:13:49 AM •
Panasonic...
•
Answered
on Apr 24, 2010
•
279 views
Resetting lamp life after changing lamp
Hold VOL - on the TV
then aim the remote at the TV (watch so that your arm doesn't block the
remote signal and press PIP or the SPLIT button. Do this together for
at least 5 second. I hope this helps, best wishes.
4/27/2010 12:12:30 AM •
Panasonic...
•
Answered
on Apr 27, 2010
•
193 views
Tv will not power up
yellow flashing power light codes: flashes 1 every 5 secs = one of 3 fans not spinning. 2 every 5 secs.= lamp cover open.
5,6,7,8,9,or10 x per 5 secs. are power supply voltage errors.
4/14/2010 2:56:38 AM •
Panasonic...
•
Answered
on Apr 14, 2010
•
626 views
Not finding what you are looking for?