Kenwood Excelon KAC-X521 Car Audio Amplifier - Page 5 - Answered Questions & Fixed issues
Which way to run my current setup? Help!!
Put the kickers with the xplode 1 per channel giving each sub around 450-500 watts. Make sure you select a good ground connection, use think copper wire and both connections must be tightened enough to not move. 10 gauge is good. Run think battery pos+ cable wire from your battery to your apps install spot. Have a fusible link in between the battery and amp. Dont run your speaker wire or rca amp cable with your pos+ wire or it will pick up current causing a high pitched tone. Run remote connection to blue wire on radio harness or to the fuse box ign. Label. Make sure them kickers have a tight seal, and adequate air space. Ported boxes do hit harder but i prefer all sealed myself. Face subs to back of vehicle and roll windows down 15 percent. Good Luck. Holler Back
10/3/2021 6:47:09 PM •
Kenwood Car...
•
Answered
on Oct 03, 2021
•
88 views
I have a kenwood cd reciver and I can't turnoff standby mode
This is usually an indication that the power board has a bad component and the signal wont switch on. The problem is usually related to capacitors and unless you want to replace the whole power supply (if you can find it,) the repair is down to the individual components and it technical in nature requiring troubleshooting gear and soldering skill
9/30/2021 4:17:35 PM •
Kenwood Car...
•
Answered
on Sep 30, 2021
•
56 views
Code for Kenwood DPX-044
The code is based on the serial number of the set. There are companies that will sell you the code. If it came with the vehicle as factory standard issue, the dealership will give you the code if you show them the registration document with VIN Number. Also look for a small white sticker in the glove box or the owner's manual.
https://www.google.com/search?q=Code+for+Kenwood+DPX-044
..
2/28/2021 6:35:15 PM •
Kenwood Car...
•
Answered
on Feb 28, 2021
•
129 views
How do I unlock my Kenwood KDC 7009 receiver
Press the "Auto" button and "Track up" on the face of Radio at the same time until the four dash lines disappear. Enter the security code using your Kenwood remote. Press and hold the 1 then the 6 preset keys until the display shows the letter 'C'. Enter the Security code using your Remote
2/19/2021 2:24:29 PM •
Kenwood Car...
•
Answered
on Feb 19, 2021
•
257 views
Not finding what you are looking for?