20 Most Recent Yamaha DGX630 - Digital Piano - Page 5 Questions & Answers


You can use the Line In jack, but you will probably need to use a mic preamp to raise the mic output sufficiently. You can try using an inexpensive mic from an amateur karaoke system or Guitar Hero etc. If that mic has no 1/8 inch mini phone plug, you can look for an adaptor, or have a tech type person set the mic cable up for you. If you want better quality, borrow or buy a professional vocal mic which uses an XLR cable and adapt the cable to plug into the 1/8 inch Line In jack on the keyboard. As I said, if the mic level is not loud enough, you can use a mic preamp, such as the ART Tube Mic Pre, which you can find used, or on a clear-out for maybe $25 to $35. Use a cable with a 1/4 inch connector on one end and a 1/8 inch connector on the other, to connect the mic pre output to the keyboard Line in. Plug the mic into the XLR input of the mic preamp. This will work 100%. Just adjust the mic preamp level controls carefully.

Yamaha Music | Answered on Nov 03, 2018


Yamaha has the user's guides available as PDFs for most of their instruments on their site: http://download.yamaha.com/top/?site=usa.yamaha.com&language=en . Enter PSR-6000 or select Pianos & Keyboards > Portable Keyboards > PSR-6000 and then press Select.

The link to the manual will display below the search area.

I hope this helps.

Cindy Wells

Yamaha Music | Answered on Nov 03, 2018


Is there a pattern to the wrong notes ( eg all up a semitone ? )
If so you could have altered the tuning.

Try a master reset:

Hold down top key whilst turning on. This will reset to factory setup.

See attached for individual reset procedures:

25994124-fpyhhfwmpgxwcy5h54afrf2k-3-0.jpg

25994124-fpyhhfwmpgxwcy5h54afrf2k-3-2.jpg

25994124-fpyhhfwmpgxwcy5h54afrf2k-3-5.jpg

Yamaha Music | Answered on Nov 03, 2018


That sounds like a problem with the contacts in the pedalboard or a short in the wiring harness. I'd suggest calling a tech in. You could cause a bigger problem if you aren't experienced.

Yamaha Music | Answered on Oct 08, 2018


Google (Yamaha)(mr-700t)(manual) without parens.

Yamaha Music | Answered on Sep 15, 2018


Look for any drag of the key to the case or adjacent keys. Beyond that, the silicone rubber contact dome probably is damaged and needs replacing. Unit has to be opened and serviced. Parts are pprobably available from YamahaAmerica in CA.

Yamaha Music | Answered on Jul 28, 2018


Go to Yamaha America by phone in California: (888)-892-6242 ask for "parts" Have your model number and serial number ready and which keys are bad. I assume you are talking the keys are showing mechanical damage, as an electrical problem like contacts requires different parts to repair.

Yamaha Music | Answered on Jul 28, 2018


Possible causes:
PSU fault.
Power (audio) transistors overheating.
Wrong speaker impedance.
Dry joint.

Needs technician to check.

Yamaha Music | Answered on Jul 20, 2018


The fact that ALL keys except G's and D flats are not working, points to a possible matrix or multiplexing problem.
As shown in the simplified schematic, if any traces (PCB tracks) from the mutiplexer / controller IC are broken, eg if the board has a crack, this could disable all identical notes for all octaves.
Otherwise the controller itself may have a fault.

(Some non-related info):
In reality, the synth's matrix is a bit more complicated than the basic sketch shown for explanation.
Diodes are included per key to prevent 'phantom note playing' and to isolate keys.
Velocity-sensing uses two set of contacts to sense timing from A to B contacts when key is struck.
matrix-lel300aiibprjvzlzqarihys-5-0.png

Yamaha Music | Answered on Jul 20, 2018


Most Clavinovas can be removed from the stand by simply looking underneath and locating the fixing bolts. Yours will need lo be laid down onto the back edge, locate the bolts at the top of each leg, unlug any cabling for sustain, mains before laying down.
See attached
image1-hkvzf2teq5seftdrfl2ij2t0-4-0.jpg

Yamaha Music | Answered on Jul 11, 2018


Hi
The normal reset is to hold down the highest note ( furtherst white key to the right ) at the same time as turning the instrument on. This will initiate a factory reset.

Yamaha Music | Answered on Jul 11, 2018


Firstly determine that the power supply you are using is providing the correct voltage, check with a multimeter.
If it is correct then you need to open the piano. Look inside where the power plugs in check the little black socket and ensure that there are no breaks where this is soldered to the circuit board - very common problem. If so resolder or replace socket. Does turning the switch on make the red light come on - if not and socket is soldered correctly - suspect the switch - check continuity wilth multimeter, if switch is ok check voltage across pins 1 & 5 on CN2 on board this should read around 12v. if this doesnt show a voltage it is easier just to replace the whole DCIN board # WM227400

f9681a1fbf409ffee5f93a38f7268d10e881e7ae_480x480-hkvzf2teq5seftdrfl2ij2t0-4-0.jpg

Yamaha Music | Answered on Jul 11, 2018

Not finding what you are looking for?
Yamaha DGX630 - Digital Piano Logo

6 questions posted

Ask a Question

Usually answered in minutes!

Top Yamaha Music Experts

Michial Gueffroy

Level 3 Expert

1140 Answers

Mike

Level 3 Expert

4367 Answers

Brad Brown

Level 3 Expert

18154 Answers

Are you a Yamaha Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Yamaha Music

  • Yamaha Music

Most Popular Question

open case repair power supply

  • Music
Loading...