Kyocera FS1370DN Laser Printer - Answered Questions & Fixed issues

First you have to upgrade the firmware to the latest. If the error code appears again, then you have to replace the main pwb assy (controller).

thanks but where do i find the fuser of the kyocera in the printer

This is refer to communication error between the printer and the extra drawer. If you power on the printer without an extra pf unit, does the printer power on?

Main PWB is defective. So it has to be replaced.

First try to change a cable, max 3m USB, max 100m ethernet. Also try to update the printer's firmware.

Press Menu button, then press the up arrow until you find the Adjust/Maintenance. Press the right arrow and search with the up arrow the Service choice. Then press the right button and search with the up or down arrow for Maintenance. Press the OK twice and the Install MK will disappear.

Control PWB - Operation panel PWB communication error. You might have a bad operation panel or the connector to the panel may be loose. communication error

Empty the waste toner from the back side of the drum unit. Then remove and reinsert the waste toner sensor connector from the controller assy (main pwb).

1. Remove the printer in System Preferences ' Print & Scan 2. Added the printer, again 3. Under the IP tab at the top of Add Printer, I chose the LPD option to the right of Protocol, instead of IPP

try to re-install its driver

Well you enter to the service and run drum refresh or you can take the drum unit and the transfer unit clean it with soft dry tissue, and you can use air to blow the dust inside the machine, if you donot know how take the parts out, let me i will send you the service manual. I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Printing with envelopes is a hit and miss affair. The best ones to use are the ones you have to lick. Dont think of using the ones where you have to peel the strip off. Also make sure you tell the pc that you are printing evelopes as this will allow the fuser to run cooler so as not to melt the adhesive too much. crinkling is usually down to excessive heat.

make sure your cassette paper guides are snug to paper or push the system/counter button look under common settings and change the size to letter

try updating print driver

I don't think you are looking at coverage I think you are looking at toner levels

its a fold down tray on side or in front of machine depends on your model

Mrs lina p try to use WD40 I think it will help you

this c 6000 mean abnormal temperature

get it service by the technician the cost is tax deductible and will be fixed