20 Most Recent
Symbol MC50 Pocket PC - Page 2 Questions & Answers
How do I restart my
There is a reset button on the back, bottom right hand side of the device. This could be pressed using the stylus
How do you silence the beeper?
Start --> programs --> File Explorer --> Windows --> CtlPanel --> Scanner Settings --> Scan Params --> Change Wav file and Start Wav file to some other sound. Thats the only way i've found to quiet it down.
I have three pocket pc--symbol
in settings go to wireless manager and turn wlan on.in some phone there is a quick acess key on the side for this.
please post comment
I have a Symbol MC50
Welcome to Fixya
Routers has DHCP capability which enables them to provide IP address to computers and this is automatic unless you set the the router to manual. Inorder for you to verify this capability, you need to connect a computer to the router and go to command prompt of the computer and type ipconfig. If you are not getting any IP address then the problem is the router.
Please get back to me for any update.
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
I can not get Symbol MC5040 to connect to the
Hello,
What you need to do is to carefully down load the symbol fron the internet with another computer system then copy it with a flash drive on make use of USB cord to transfer the symbol to your MC pocket PC so as to able to load in to the net this recommendation is for USB cord .
If you like to make use of flash drive, after down loading the symbol from the net plug in your flash in to the PC you are making use of copy it from MY COMPUTER in to the flash , then remove the drive carefully the install it to your pocket pc through the USE pot open it and then up load it.
Good luck.
Thanks.
My symbol mc50 scanner wont
Hello,
it is possible that if you changed the battery you forfot to move the slide button next to the battery to the correct position. It often happens to me :-) Please check it, its on the right top corner of the battery, you should not see the red marking, if there is the correct position.
I have a Symbol MC50
If the scanwedge program is loaded and enabled, your scan engine is bad. Check to see if scanwedge is running and scanning is enabled
HOW TO RESTORE FACTORY DEFAULT
There is a program you can download from symbol/motorola and place on a sd card and follow the instructions with the card and program. Otherwise send it to me and I will do it for $100.00.
I purchased a Symbol MC50 MC5040 WIFI Bar Code
All MC50s are equipped with an scanner, if you would read out the Full Product number (like MC5040-XXXXXXXXX) of your device. Then can you check which kind of scnner is built in. The Software is usually preinstalled in the /Application folder.
Which number is the serial number on a MC5040?
Underneath the battery there is a white sticker located in the top right hand corner. The first number is the model number and below that is teh serial number, e.g.
MC5040-PQ0DBNEE1WW - model number
[BARCODE]
05295520200460 - serial number
[BARCODE] [MANUFACTURE DATE]
hope this helps.
I have a Symbol mc50 which will not power up. The
Given that the MC50 has long been EOL, my suggestion would be to scrap your unit and replace it with a Janam XM66 - closest thing in terms of size/weight but faster performance, more rugged, better scanning. In the end, you'll spend less money. Good luck!
Not finding what you are looking for?