20 Most Recent
LG WD-80130F - Page 8 Questions & Answers
What dose cl stand for and how do you fix it .
lc is of Child Lock and can be set by squeezing the PRE-WASH(*CHILD LOCK) or
TUB CLEAN(*CHILD LOCK) for 3 seconds
At the point Child lock is set,
To unlock Child Lock system, press the same button again.
I have a LG WD-1018C
The error code "PE" stands for pressure sensor error. This is typically caused by a malfunctioning water pressure sensor switch.
Model WF-T802. Why doesn't it start?
Would not finish the rinse cycle. I replaced the water inlet valve which solved the problem. Same problem again. I replaced the water inlet valve but now it doesn't start.
Model WT5001CW top loader. OE error. Why doesn't it drain?
If your washing machine cannot either drain or spin then the water level control could be faulty. Open up and look at the washers control panel and also look for a plastic tube attached to the water level valve. If appears to be clogged clean it out with vinegar. If the valve itself is broken or rusted then. it may need to be replaced.Have a person that repairs washing machines to have a look at it.
Lg top load washing machine leaking from bottom
Many things to cause that. Put sheets of newspaper slid underneath between the feet. Run a wash, slide the paper out every 10 minutes to locate the area where the leak is. Wait for the cycle to finish. Pull the machine out and tip it towards the wall. Make sure it won't fall forward by getting someone to hold it.
Could be;
hole in the drum.
leaking pump
leaking hose clamps
perished rubber pipes
leak in the drain hose
The wet spots on the newspaper will pinpoint the leak area.
..
Lg washing machine drum light stays on and wont let me turn the
Solution. Unplug the machine. Hold the power button for 10 seconds. Plug back in. Push the power button and the washer should turn on. Walk away leaving the machine on. When I did this, I came back to find the drum light off and machine would start on command now. Good luck.
Not finding what you are looking for?