20 Most Recent
Kenmore 600 3.5 cu. ft. Top Load 110-2962 Washer - Page 8 Questions & Answers
My Kenmore 500 will fill with water but after it fills the water won't shut off.
If your Kenmore 500 washing machine is filling with water but the water won't shut off, it could be caused by a few different issues. Here are a few things to check:
- Water inlet valve: The water inlet valve is responsible for controlling the flow of water into the washing machine. If the valve is faulty or stuck open, it may cause the water to continue flowing even after the machine is full.
- Water level switch: The water level switch is responsible for detecting the level of water in the machine and shutting off the water when the machine is full. If the switch is faulty or not functioning properly, it may cause the water to continue flowing.
- Wiring issue: There may be a problem with the wiring or the electrical system that is causing the water inlet valve or the water level switch to malfunction.
To determine the cause of the problem, it is recommended to bring your washing machine to a professional appliance repair service for further diagnosis and repair. They will be able to test the water inlet valve, water level switch, and other components to identify the source of the issue and recommend the appropriate repairs.
Front load kenmore elite washing machine is leaking suds in spite of using HE detergent
Hi,
please lower the amount of water in the washer machine by one-third if possible and do the same for the amount of detergent that you usually use. If that fails, please power cycle your washing machine. If the leaks are not coming from the top of the washing machine via overflow. Then, you might need to schedule for a repair of the washer.
Thank you.
Kenmore front load washer rocks when spinning and cant seem to get it level so that it doesnt rock side to side
By 'side to side' I'm assuming you mean it's rocking left to right and not front to back? The most common direction it will rock will be on a diagonal line. How far is it rocking? A small amount or a large amount? Small amounts can be adjusted. If it has recently started rocking badly, especially on high spin, it might suggest there is another issue that needs looking at.
Most machines only have adjusters on the front. Wind both feet all the way In then wind them both Out again 5 full turns. You might need a helper for this as you will need to tilt the machine to take the weight off the feet. Physically push and pull the machine to see which direction it is rocking. It will always rock on the highest points. On the corner that lifts wind that foot Out half a turn and the other foot In half a turn. Repeat this using Half or Quarter turns until the machine levels out. If the rocking direction changes sides wind the foot you have just wound Out back In the half/ quarter turn you have just used but Not the other foot.
You might need to 'fine tune' with more eighth and quarter turns over the next few times you use the machine. At this point you only need to adjust the foot that actually lifts off the floor.
If it rocks evenly down the centre line of the machine it might be the actual floor causing the issue.
Not finding what you are looking for?