20 Most Recent
Dyson DC35 Handheld Vacuum - Page 7 Questions & Answers
Dyson dc24 no suction from hose
If your Dyson DC24 vacuum has no suction from the hose, it could be due to a blockage or a problem with the hose itself. Here are a few things you can try to troubleshoot the problem:
- Check the hose for any blockages or kinks. Remove any blockages or straighten out any kinks to restore suction.
- Check the hose for any visible damage, such as holes or cracks. If the hose is damaged, it will need to be replaced.
- Check the hose connection points to make sure they are secure and not loose.
- Check the filters to make sure they are clean and not clogged. If the filters are dirty or clogged, they can reduce suction.
- If the problem persists after trying these troubleshooting steps, you may need to take the vacuum to a repair center for further diagnosis and repair.
Dyson v11 motor not smooth
Hi,
if the calibration steps (often) recommended by the manufacturer do not work, please switch outlets and monitor performance of the motor from the different power source. If this fails, then you might next swap your current motor with another one from ebay or alixpress and test the vacuum again with the substituted motor.
Thank you.
Why does my Dyson D43 dust canister not snap into place?
I also have a dyson vacuum but it is an old version. I have been having that problem recently and i researched the internet about the similar subject. People are having so many complains about the release button . Hopefully you will solve it by calling the service to replace it with a new dyson. Otherwise the problem you are having will continue
good luck??
My Dyson DC75 Brush is constantly spinning and will not turn off.
Hi,
it sounds like the vacuum has received too much power at one time. If you've left it plugged into an outlet that varies in voltage or current from the standards of the vacuum, this might be the cause. You might need to use a connecting cord (that acts like a reverse outlet) to suck the excess power out of the vacuum and into a mobile battery/capacitor. This allows you to save any energy removed from the vacuum.
Thank you.
Dyson V6 leaves rubber marks on hardwood floor, all the wheels are free spinning so what do I do
If you had rolled it through some kind of petroleum based solvent like acetone, gasoline, kerosene, benzene, diesel fuel or, sometimes, alcohol, you may have converted the rubber tires into something akin to bubblegum. If you turn it upside down and feel them, check to see if they are sticky or gooey. If so, you'll have to replace them. Good luck.
Dyson dc21 motorhead stopped working
Remove the motor head from the extension pipe and look carefully at the mounting hole the pipe plugs into. Next to the main hole there should be 2 pin connectors, either above it or below it. This is the power supply connector for the head unit. GENTLY use your finger to try and move these pins, they should not move. Sometimes these pins can break and stop the motor working. Sadly they cannot be repaired so you might have to replace the whole motorhead.
Not finding what you are looking for?