Weslo Cadence G 5.9 Treadmill - Answered Questions & Fixed issues
Treadmill will not power up or work
see the video and proceed according. and fix it. However you must test the c. breaker from your outlet box, put some lamp desk , and see if work, if does the problem is the machine for troubleshooting, and contrary case. Rsset the c. breaker.God bless you
Worked fine for a year, now feels very strange walking on it, have tried lubricating but does not help, feels like bouncing or vibrating while walking, what can be done?
Treadmills often vibrate, just a common side effect of running on it.
Location of your treadmill is key most of the time for reducing vibrations or noise due to impact.
This impact is spread to the floor from the feet of the treadmill, which is a small surface area.
You want to make sure that your treadmill is leveled and it is best that it is placed on a rubber treadmill mat.
This will absorb the impact, as well as the sound and the shock of the vibrations.
A thick rubber mat will act as both a sound and impact suppressor between you, the machine, and the floor. The thicker the mat, the better.
If this does not fix the issue, we would be happy to help you further diagnose the problem by phone 888-713-2880 or by chat at
www.sportsmith.net
We also have rubber mats available for your treadmill if you need a new one! Otherwise, good luck on the repair :)
Belt won't start
Does the incline work? if so, the controller is most likely bad.
Replaced motor and motherboard board through warranty but belt still won't work. Not even the power noise will turn on.
The motor, or a connector to the motor, or the controller is faulty. If you can measure DC voltage at the motor (up to 90VDC), but the motor won't turn, and if you can manually move the treadmill belt with your hand or rotate the motor pulley (POWER OFF) with your hand, then the motor's dead. Even IF it was replaced under warranty.
If you can't measure any DC voltage to the motor under any conditions, then the problem is in the controller or a connector. Try measuring directly at the controller board.
Strange Clicking
You have a minimum 90 day warenty,normally one year.Take the unit back and get a new one.This is why you get a warnty with things you purchase,so if anything goes wrong,you can get it replaced.Or repaired,your option.
Weslo Candence 5.9 won't run after being moved
Check for any loose electrical connections between control panel and motor especially any plug together connections. Moving may he have loosened or unplugged one of these connections. Hope this helps.
Smoke
May be the motor or belts/bearings needing lube. I have same problem.
Burning smell when useing
Hi! Same problem here; may be the motor bearings are going.
I am checking what can/needs to be lubricated.
Ross
Belt motor
see the video attached . Lube the rollers bearing front +back too.God bless you
Belt doesnt run
see the video how to lube the deck belt.
2) LUBE the rollers bearing too3) Test the drive belt motor,4) Test the input voltage motor, if there are the motor need repair see my personal TIPS for troubleshooting help5) Test the output voltage board, for input voltage motor, if there are NOT the board is faulty.see the block diagramGod bless you
The reset button is on reset, the elect
adjust the reed swtich, see the diagram attached,clean it, and tight very well the connector2) replace the batteries and clean the contacts battery very well.God bless you
Starts then stops
1) LUBE the deck belt, lack of maintenance possible you have deck worn. the machine protect itself shut down for electronic system2) LUBE the rollers bearing too.3) measure the input voltage motor, if there are the motor need repair.4) measure the output voltage board, for input voltage motor, if there are NOT the board is faulty.see the block d.God bless you
Not finding what you are looking for?