20 Most Recent Vision Fitness T9250 Treadmill Questions & Answers

Try to check the carbon brush of the motor. If it's OK then the motor control board would be faculty If you wish to get some more details about treadmill repair then check the following link http://electro-medical.blogspot.com/

Question edited for clarity and toss in some CAPS. It is sold as an entry level fitness bike, but try the troubleshooting or contact them direct.

Troubleshooting ' Vision Fitness - United States

Vision Fitness https://www.visionfitness.com > eng > support > troubl... Make sure the treadmill switch is turned on. Solution: Check the power cable for crimping. Unplug the treadmill from the wall outlet, then wait 60 seconds to ... ..

I have this same issue, have you found a solution?

Your diagnosis is good. The wheel should be more centred. You are not alone. Contact the maker, the details are in the link. https://www.google.com/search?q=vision+fitness+u40+grinding+noise ..

https://www.youtube.com/watch?v=Ww6Ns4GwhYw https://www.youtube.com/watch?v=l6VauCpABhQ

If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

1)probably a faulty speed sensor 2) the speed sensor is not plugged in properly.3) possibly a faulty motor test for 115 vca without load 4) control board or lower board for measure 115 vca and +5vca 5) Run the calibration sofware for easy diagnotic see the diagram attached.6) Test the transformer for primARY VOLtage and secondary voltage. see the TIP. The error codes will differ between makes and models but could be e1.http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitnesshttp://www.fixya.com/support/r10786838-test_procedure_dc_motorSincerely. Happy New Year . G-d bless youernesto cuadramanagua,nicaragua c.a.

First thing to do with these folding vision fitness treadmills is REPLACE THE MAINS SUPPLY CABLE They were supplied with very poor quality cable that cause issues like juddering stopping and speed fluctuations.

My guess is the drive belt has come off. Open the plastics up slightly and look in with a torch.

There is a special lubricant spray for treadmills that you spray. injection pump. The air injection pump is designed with a check valve inside which only allows air to flow in one direction, preventing exhaust gases from escaping through the air pump and only allowing air to enter. When this check valve fails, moisture is able to get inside the air pump. Make sure you don't have dirt and dust build-up before spraying.