Top 20 Ricoh Aficio 1515MF All-In-One Laser Printer - Page 9 Questions & Answers


USB is not supported on this Unit

Ricoh Aficio... | 456 views | 0 helpful votes


Um.. I don't see an "online" or "escape" button anywhere on the printer...

Ricoh Aficio... | 4,636 views | 13 helpful votes


Remove the tray and check the wire you mentioned, that it is connected to the paper end sensor.
Probably the paper end sensor has its plastic legs broken.
If so, replace the paper end sensor and you will solve the error message.

Good luck and please rate me, thanks.

Ricoh Aficio... | 480 views | 2 helpful votes


a minha ricoh 1515 vem apresentando constatemente o codigo cs 929, como fazer para solucionar este problema. pois os tecnicos não resolvem.

maninhosales@hotmail.com.


emmanuel buonafina.

fone 81 32425587
81 86123213.

Ricoh Aficio... | 314 views | 0 helpful votes


default login: scanner
default password: password

Ricoh Aficio... | 1,525 views | 3 helpful votes


start by checking authentication... make sure your smtp server login is correct, also change your smtp name to ip format... run cmd and ping your mail server... example ping mail.server.com it will respond its ip address

Ricoh Aficio... | 506 views | 0 helpful votes


The first thing to try is to turn the machine off, then back on at the red "main power" switch located on the left side of the machine. If the code returns it is indicative of firmware problems or a loose connection.

At this point I would seriously recommend getting a service tech to come out. However, if you want, you can take off the back cover (MAKE SURE THE POWER CORD IS UNPLUGED) and double check all of the connections by (GENTLY) pressing them into their connections. Hope this helps. Let me know.

Ricoh Aficio... | 1,381 views | 3 helpful votes


Transmission Settings!

Ricoh Aficio... | 1,170 views | 0 helpful votes


Ok, you do not want DCHP to be on. Select IP address and enter the IP back in. Press ok, and ok, until it says "programmed"

Hopefully, you did not wipe out the subnet address, and gateway address. It would be easier to print a config page out to see. If you did, get to a command prompt on your computer, and type:

ipconfig /all --> then enter. That will give you the subnet and gateway if you lost it. If you have any problems, email me.

Ricoh Aficio... | 794 views | 0 helpful votes


you need to deactivate the pcu alarm.for a detailed explanation let me know if you still need to know how to do it

Ricoh Aficio... | 1,195 views | 0 helpful votes


Depending on the kind of copier, all copiers have toner sensor. The sensor flip or botton is out of position. When a toner is inserted in a copier, it is either displacing a flip which open light to a sensor or pressing a sensor botton. In either case a signal in sent to the processor that there is toner or not. Check in the toner chamber, you will it either blocked with dirt. First try power cleaning "Use air preasure".

Ricoh Aficio... | 286 views | 0 helpful votes


well..I lost the connection during our chat.

Ricoh Aficio... | 35 views | 0 helpful votes


is thera paper jam sensor wigle paper in and out unplug unit from wall 2 min ten back in hit sensor with paper hit reset on unit

Ricoh Aficio... | 672 views | 0 helpful votes


Make sure her account is not set to send to a group. Recheck all of her settings.

Ricoh Aficio... | 114 views | 0 helpful votes


contact service provider

Ricoh Aficio... | 56 views | 0 helpful votes


Hi , this problem are mainly caused by country code settings in the machine it might be that the country code settings were cleared some companys does not put the jumper on the battery on the back of the fax unit so when there is a power failure the country code resets back to default if you can tell me wich country you are i can get you the correct code and send you the prosedure on how to correct this .

Ricoh Aficio... | 197 views | 0 helpful votes


Press on duplex button and scan your originals one by one on the platen mode (exposure glass). You cannot use the ADF for this function.
After every scan press the Start button.
After the last page please press the enter button as displaying in the display.
Then the copier itself can finish making duplex copies as you wanted.
Good luck and please rate me, thanks.

Ricoh Aficio... | 251 views | 1 helpful votes


Search here i allredy posted here in forum;)

Ricoh Aficio... | 210 views | 1 helpful votes


Probably, you will have to call your local Ricoh servicer for repair.

Ricoh Aficio... | 41 views | 1 helpful votes

Not finding what you are looking for?
Ricoh Aficio 1515MF All-In-One Laser Printer Logo

297 questions posted

Ask a Question

Usually answered in minutes!

Top Ricoh Office Equipment & Supplies Experts

gggg

Level 3 Expert

904 Answers

Adorjani Laszlo

Level 3 Expert

1316 Answers

quennie732

Level 2 Expert

422 Answers

Are you a Ricoh Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Aficio Ricoh

  • Aficio Ricoh

Most Popular Question

error code sc 120

  • Office Equipment & Supplies
Loading...