Top 20
Ricoh Aficio 2022 All-In-One Laser Printer Questions & Answers
I have had this aficio
Does the copier have a printer /scanner sd card installed and a network card installed in the machine as this is the best option to use the machine as a printer
Error code SC 565 Ricoh MP 2550
SC565
*Heat lamp consecutive on error - Broken main fuser connection
*Heat lamp consecutive on error - Check HR thermistors with SP1-106 001 (ctr) and 002 (ends)
*Heat lamp consecutive on error - Heat roller lamp defective
*Heat lamp consecutive on error - Power Supply defective
Error sc548 aficio 1022 ricoh
if the above solutions failed, ask a technician to clean the thermistors, as toner build up on them and then give you the same code, have also found that power surge or power failure also cuase this code to come up repeatedly
What does sc392 mean on a mp2510
Someone forgot to remove the tone
seal of the PCU
ID sensor defective
TD sensor abnormal
Drum does not turn
Development roller does not turn
Poor connection of the PCU
SC 315 ERROR
Code doesn't exist! You're asking for help and can't even get that right!
Error sc542 service
SC 542 Fusing temperature warm up error.Fusing lamp defective,poor fusing unit connector,thermistor warped or broken,thermostat has tripped,power supply defective.After verify the componenets try reset the error.Enter in service mode:Press the yellow key and press 107 and keep pressed the stop key 3 second.Touch the SP window on screen open the front door and turn OFF the copier.Wait 1 minutes ,close the front door and turn ON the copier.If the error code persist change the upper fuser roller and the thermistors.
My printer multifunction Aficio sp C240sf show the
For this model specifically, the following will get you into service mode.
Hit "Clear / Stop" Buttom then "107" then hold down "color print" buttom for some sec then you are in service mode
If that doesn't work, you can also use Clear/Stop,1,0,7, Clear/Start.
Each key should be pressed and held until you hear a beep
Lost admin password
Cannot be done. Have a tech come and replace the NVRAM. It will cost you a lot of labor.....
Clear admin password
You cannot. To remedy this you have to replace the NVRAM. Then all the settings for the machine must be re-entered. Not a job for the unexperienced tech or novice. See this all the time and will never understand why people change it.
My photostate is giving half copy dim
it's either your drum or cleaning blade problem.You had to do PCU maintainance service ,if not be prepared thousands or hundreds bang by copier technician
Not finding what you are looking for?