20 Most Recent
Harman Kardon CDR2 2-Disc CD Recorder - Page 6 Questions & Answers
Enter chat room
Hey there it seems to be a common problem with this model and there have been many complaints about it. Harman are saying that the sound boards are made in China and they are using inferior components. they rekon if ya get in touch with there spare parts department they will send you out a new one.
Speaker setup
This is a hard problem when one is not looking at the speaker. But let me give you a little help if I can.
Try pluging the subwoofer into the speaker port of the Pc
Make sure your pc is turn of.
2) I believe the subwoofer has four jacks at the back.
3) Plug each of the speaker into the jack that says speaker
4)Now, if you are confuse of the in and out, on the subwoofer I understand. I believe you should be from out of the subwoofer to the in of the speaker. again, I cannot see at the back of you subwoofer.Only speaker from exprience.when you are done, turn your pc back on and turn the speaker on. making sure the volum is turn low.
good luck
How do i factory reset my Harman Kardon avr 55 receiver
Troubleshooting Guide
Processor Reset
In the rare case where the unit's operation or
the displays seem abnormal, the cause may
involve the erratic operation of the system's
memory or microprocessor.
To correct this problem, first unplug the unit
from the AC wall outlet and wait at least three
minutes. After the pause, reconnect the AC
power cord and check the unit's operation. If
the system still malfunctions, a system reset
may clear the problem.
To clear the AVR 520's entire system memory
including tuner presets, output level settings delay times and speaker configuration data,
first put the unit in Standby by pressing the
System Power Control button 2. Next,
press and hold the Tone Mode 8 and the
FM Mode Selector ^ buttons for three
seconds.
The unit will turn on automatically and display
the RESET message in the Main
Information Display Y. Note that once you
have cleared the memory in this manner, it is
necessary to reestablish all system configuration
settings and tuner presets.
[email protected]
My harman kardon DPR 2005 switches itself off after turning on after 5 seconds.
If this is an amplifier or receiver, this is often due to either a shorted output (disconnect speaker wires from the unit and see if the issue still happens) or an issue with the output stage internal to the amplifier such as a shorted transistor that is causing a DC offset or similar. Try disconnecting the speaker wires from the unit and report back with results and details.
Not finding what you are looking for?