20 Most Recent
Linksys StackPro II 100BaseFX Distance Extender (DSHFXSC) - Page 9 Questions & Answers
Wrt 150 router windows install
CALL THE PEOPLE OF THE MODEM OR THE INTERNET SERVICE PROVIDER OR LOOK UP THE NAME OF THE MODEM ON THE INTERNET
2/28/2014 1:43:57 PM •
Linksys...
•
Answered
on Feb 28, 2014
URL call is Disabled. Polycom IP450. Anybody know
Go to your asterisk CLI by typing: asterisk -r -vvvvv and check the messages that comes across. You may find a "NOTICE" stating failed to register and the reason why. My case was an ACL permission, which is the Deny or Permit section of the extensions config. Here is the default, which will allow anyone to register and is not recommended. Deny: 0.0.0.0/0.0.0.0 Permit:0.0.0.0/0.0.0.0
2/27/2014 2:53:48 PM •
Linksys...
•
Answered
on Feb 27, 2014
Unblock facebook
This is normally on your router page settings. Access your router's management page using your computer browser. Then under Access Restrictions tab, check category
Website Blocking by URL Address
Facebook shouldn't be in the list then save the settings.
2/24/2014 12:28:56 AM •
Linksys...
•
Answered
on Feb 24, 2014
Sudden shut down
It's possible that this is a hardware failure or a power adapter failure. Try to reset the unit and reinstall it again. You can also check for firmware updates available online. Try to use other power adapter as well with the same specs with the original power adapter.
2/24/2014 12:16:39 AM •
Linksys...
•
Answered
on Feb 24, 2014
I can't ping my router
Your router may be set to not respond to pings. Are you sure you have typed the correct address? From a command prompt (open start menu and run cmd.exe from the run box or search box, depending on operating system) and type ipconfig to see the gateway ip address, which is the address of your router.
1/17/2014 2:48:53 AM •
Linksys...
•
Answered
on Jan 17, 2014
Need to change login and pass word for my net gear royuer wndr3700
If it is set to the default the username should be "admin" and the password should be either "admin" or "password". If they have been changed and you cannot access it, you will have to factory reset it by holding the reset button down for 10-15 seconds then access it using the credentils above.
1/17/2014 2:29:38 AM •
Linksys...
•
Answered
on Jan 17, 2014
Put passward brodband
if you type 10.1.1.1 into your internet browser you will be able to access your router settings. you can set up the password there
1/11/2014 1:47:08 PM •
Linksys...
•
Answered
on Jan 11, 2014
Not finding what you are looking for?