Toshiba E-studio 2330c 2830c Color Multifunction Copier - Page 4 - Answered Questions & Fixed issues
Reset Toshiba Estudio3055c
1. Turn the power of the equipment OFF and check the
connection of the HDD.
- Connector and harness check
- Check if the connector pins of the HDD are bent.
- Check if HDD for other equipment is not installed.
- Check if SRAM for other equipment is not installed.
2. If the error still occurs after step 1, perform the following.
- Perform HS-73 Firmware Assist mode -> Key
Backup/Restore and check that each Key Status is
"OK".
- If not, recover the key (copy "SRAM Key Status" to
"FROM Key Status" or vice versa).
3. If the error still persists after step 2, perform the
following.
- Perform HS-73 Firmware Assist mode -> Format
HDD, and then install "System software" (HS-49
Firmware Update mode -> SYSTEM SOFTWARE
(HD Data)).
Notes:
The following items will be deleted by HS-73
Firmware Assist mode -> Format HDD.
• Message Log
• Job Log
• Spool Data (Print, Email reception)
• Template
If F101_1 occurs with secure HDD or the error
persists after performing step 3, perform step 3 after
performing HS-74 HDD Assist mode -> Revert
Factory Initial Status HDD.
4. If the error persists even after step 3, replace the HDD.
5. If the error persists even after step 4, replace the HDD
harness.
6. If the error persists even after step 5, replace the SYS
How to fix a toshiba BARCODE Printer ribbon take up roller
Hi,
Are you referring to the platen roller? The platen roller is the cylinder that's underneath the printhead which pulls the labels from the roll/box and then pushes it at a certain speed so that the printhead prints onto the label. The platen roller is usually coated in rubber and you can check if the platen roller has some eroded or cut sections.
Unfortunately, the platen roller is a consumable item, you'll need to replace the platen roller. Take a look at our blog for more information about the platen roller.
https://www.bartechsystems.com/barcode-printer-not-working/
When power on toshibs e studio 257 no power in the display , green led iluminating in the display panel
The most common problem is the loss or corruption of the system files. It is necessary to consult the service manual of the equipment in order to enter the service mode and to check the status of the system files and to restore them. It can save you a lot of money that you would have paid to a technical team.https://www.anyservicemanuals.com/downloads/toshiba-e-studio-206l-207l-256-256se-306-306s-306se-306sd-356-356s-356se-356sd-456-456s-456se-456sd-506-506se-207l-257-257s-307-307s-307sd-service-manual/
Not finding what you are looking for?