I'm sorry
to say that this is potentially very bad news. The problem you describe is
almost certainly because the main bearing on the drum is worn out, allowing the
inner drum to "flop about". Grease from the bearing and rust that has formed as a result of water tight seals for the bearing breaking down causing the bearing components to rust is probably what you are seeing on your washing.
To test your bearings, open the door of the machine and by putting a little lifting pressure on the top of the inner drum, attempt to rock the stainless steel inner drum up and down.
The outer drum is mounted on springs and shock absorbers, so it will rock about (and it should do this) but the inner drum should not move up and down in relation to the outer drum. There should be ABSOLUTELY NO PLAY between the 2 drums, even the tiniest amount will mean the bearings have failed.
If the bearings are bad enough then other symptoms will typically include:
A clonking noise as you lift and release the inner drum (this is the inner drum rattling on its bearings and/or hitting the outer drum)
You will have become aware of the spin cycle becoming far noisier recently and possibly even a grinding crunching noise when the machine spins.
The drum may feel like something is crunching or stopping you turning it when you spin it by hand with the door open.
A leak from under the machine, which you will probably be able to trace to the back of the machine, coming from the centre of the drum. This is a result of the failing bearing allowing water to escape through the seal at the rear.
This is NOT a job for the uninitiated DIY enthusiast as it will mean stripping the machine and removing the drum from the chassis, splitting it, removing pressed in bearings and then sourcing and re-fitting new bearings.
To be frank, the cost of a bearing set (if they are replaceable, and most are) will be about £20 ($30) or so. But it's a long and horrible job if you haven't done it before. I know professionals who claim they can do a bearing change in under an hour, I've done a few and it takes me about 2 hours by the time I've ripped the machine apart and reassembled it after the bearing swap. A local repairer will probably attend and swap out your defective drum for a refurbished one and then take yours away so he can refurbish it and put it back in his stock. Sadly, this will take the price up to the point where you need to question if the expense is worth it or do you get a new machine instead.
Hello &
Welcome to FixYa
These 3 flashing lights indicate a fault in its
pressure system. Unplug the machine and take the top off. There will be 2
pressure switches, circular devices with a thin tube attached to them. Take the
tubes off, block one with your thumb and blow as hard as you can down the
other. Refit the tubes. Give the pressure switches a couple of good taps with
your screwdriver handle in case they are stuck. Check the wiring to the
pressure switches, pull the plugs out and fit them in again. If the problem is
still there then it seems that the door lock is bad and needs replacement,
however you can test it before replacing. If it tests fine then check the pump
motor assembly. Please
get back to me if you have any other questions.
Kevin
79 questions posted
Usually answered in minutes!
327 Questions
237 Questions
124 Questions
99 Questions
84 Questions