20 Most Recent Sunbeam 1964,1965,1966,1967 Tiger Badge/pin 64,65,66,67 - Page 2 Questions & Answers

There is chance that arcing brushes in the motor are causing the odor. They should be replaced and the armature cleaned. A sunbeam repair shop can refurbish your mixer if the parts are still available.

If you have the same heater i do then in between the elements at the bottom there is a safety swith that bends when it heats up and breaks the connection Dont mess with it plugged in it will shock the hell out of you but if you bend it down it wont be able to lift off the circut and will stay running untill you turn it off

Lower temperature will keep the room cooler. For efficiency sake, lower the temperature gradually to
68 degrees.

Hope this helped you. Thanks for choosing FixYa.

Nothing works. Have had it for 6 months. Plugged in after so long, still blinking.

compressor not working or low on freon

A partstore knows or chec online

heating element possible shorted out.

Try these: -Make sure the remote battery contacts are clean; -clean fully charged battery surfaces with a lead pencil eraser to remove oxide; -could be loose contacts or cold solder joint on remote control board, especially if dropped a lot. if not tech savvy probably better to recycle old unit and purchase a new one . good luck!

Generally means u have a bad connection at the wall or at the control module. Disconnect everywhere u can and reconnect

Possible free manual if this is the same model with wick information. http://www.milesstair.com/Sunbeam3602.pdf

Try unplugging the power cord from the wall socket and check that the connection to the blanket is good and not loose. Then plug back into the wall socket and switch on. If error still occurs then there may be a problem with the blanket.

My sunbeam XL heating pad started blinking and I couldn’t figure it out. I Unplugged a couple of times and still it kept flashing. After hours of reading post, I did what wpart suggested and now it works normal again..... I kept pushing th on off button while plugged in, I unplugged it while still hitting the on off button, I plugged it back in while still hitting the on off button annnddddd drum roll please!!!!!! It started working properly! Thanks wpart, your the MVP and award goes to you!

Wires probably damaged inside. Be carefull, I had one cought on fire. Dont like this things ever since

unplug replug blanket to control connectors plug back in this will continue to happen on these blankets you will have to reset these blankets again and again (chinese junk)

http://www.electricblanketinstitute.com/blanket-or-comforter-on-top-of-electric-blanket.html