20 Most Recent
Tricity Bendix AW1400W Front Load Washer - Page 9 Questions & Answers
It will do a full
It is possible that the drain valve/pump is faulty if there is voltage on the valve/pump. If not the program controller board is faulty and must be checked. Check the drain hose and the connection to the outlet.
Door wont open
you need to get the door switch replaced try not to damage it more till the repairman gets there
I have moved into a
You have not completed the full line. Please reply with the details required for help.
Washer mod. aw1002w stuck at
hello,
what this simply indicate from your explanation is that there has been a bridge up of power on the wires connected the jet spring (spinal or motor).
the way out from this problem,
first of all put off all forms of power supply connected to the washer then unscrew it with care using a technician tools call (screw driver )then trace the wire down to the jet spring(motor or spinal) at the back of the washer check if there is any form of born wire of loose if any then it will need a replacement but if non it then means that the motor is bad which will need a replacement .
To get a better part of the washer you are advice to order for the part from the company that produce the washer , if that will be very difficult then get the part from any store around you but make sure that you are buying the same type with the old or bad one for easy compatible.
thank you and thanks for using fixya.
Is there a way I can easily attach a replacement
Your model number is needed for more information.
It's usually stamped on a small tag in a visible location on your appliance.
Washer-Dryer- behind or on top of the control panel. Behind the door. On the lower front or side of the cabinet.
Have you taken anything apart yet?
How to replace belt on tricity bendix aw440 washer
1. remove top plastic panel (retaining screws are at back)
2. locate metal brace (12 incles long and 1/2 inch wide) on top of the cabinet (in mine it is on right edge)
3. unscrew retaining small bolts (there is one a few inches below on the inside of the cabinet too).
4. Repeat for left side.
5. push the back and front halves of the cabinet away from each other
6. slide the new belt around the front of the drum
7. reassemble
8. if you need to tension the belt wrap 10-20 turns of insulation tape around the idler pulley
Hiya,
It will be something stuck in the filter that is preventing it coming out.
As you unscrew it try twisting it from side to side , and screwing it back in again, and keep on doing that, hopefully it will eventually come out.
Hope this helps.
Every time I turn on the appliance it blows a fuse
A washer requires a dedicated electric outlet to operate properly. It is possible that the plug you have is part of another circuit and has some other high ampere drawing devices connected to it. Check to see if any other items are affected when the circuit trips (or fuse blows).
If you truly have actual fuses instead of ciruit breakers, make sure the fuse you are replacing is a slow blow type rated at the proper amperage for the circuit.
If you have circuit breakers, you might have to have a separate 20 amp dedicated branch circuit added to power the washer. (USA/Canada)
Without further details of the specifics of your situation, that is the advice to check first.
Washer is stuck on drain
Start checking that water level is OK. If water level is stuck, the machine will keep draining forever.
Check that wiring to pump has no contact to ground. If the pumpwiring is fine then it can be wiring to timer control or timer control board.
Test and repairs must be done by qualified pesonnel.
Check the water level first, that is the most common cause for this problem.
Enter the model number on one of two websites below to get parts and diagrams for your appliance:
Appliance Parts From PartSelect
Appliance Parts Pros
Water not draining
have you checked filter and checked for foreign objects in the drain pump impellor??
Not finding what you are looking for?