20 Most Recent Daewoo DWD-WD1353WC 4.5 Cu. Ft Capacity Washer 1 300 RPM 11 Cycles Chrome - Page 7 Questions & Answers

replace the water shutoff solenoid valve assembly in the mean time when the machine is full turn the tap off change the hot water hose over to the cold water tap and use the hot water solenoid button

I do not believe that is a 1E I think it's an IE error code which would be water inlet wiring or something like that. Here is the code list, scroll down until you find IE, Daewoo errors start at E2, hope this helps. http://removeandreplace.com/2015/11/02/daewoo-washing-machine-error-fault-codes/

Water Inlet Error http://www.manualslib.com/manual/738148/Daewoo-Dwd-F1011.html?page=13 Good Luck

I hd zs problem before,no problems in z water outlet,z pump

Hassan... sorry to hear of your troubles, There are definite procedures for wet equipment handling! Immediately remove ALL POWER. (THE MORE IMMEDIATE the better the results). Open the equipment to the fullest extent possible... remove excess water.. and use compressed air to help move excessive moisture away. WD40 (water displacement) is an excellent product for this purpose. If the water was clean... allow the unit to air-dry TOTALLY before even thinking about restoring power. If dirty, muddy or corrosive... rinse the unit with fresh clean water... THEN proceed with the water removal... After several DAYS... carefully look into & around electrical connections for any signs of corrosion or electrolysis... Make an inventory of part to refurbish or replace. Many connectors can be cleaned with Isopropyl Alcohol & conditioned with an anti-corrosive (no-ox compound, white lithium or even petroleum jelly) re-connected, refitted & re-used... Other parts.... NOT-SO-MUCH... Everything must be completely ABSOLUTELY dry & re-assembled before attempting to restore power. Hope this helps... Yes entire telephone exchanges have been in mud slides, hosed off... properly dried & restored to service (honest... SxS CDO).

Without more info, it sounds like a faulty water inlet valve.

It sounds like a blocked or failed drain pump.

Hi, you didn't mention the model, but on the washer/dryer combo units, the H1 means the following: Dryer temperature sensor error detected A fault has been detected with the dryer temperature sensor on washer dryer models.

• Check connections to dryer sensor
• Check temperature sensor

A soliniod must be jammed open with crud ,try putting a good cleaner through the machine clamping off the drain hose.

http://homenol.blogspot.com/ Visit this site to get some details.

replace the lock switch

the link below is for Daewoo, press the helpful button http://www.ukwhitegoods.co.uk/help/fault-codes/laundry-fault-codes/3369-generic-daewoo-washing-machine-and-washer-dryer-fault-codes