LG WM2801HWA 4.5 cu. ft. Front Load Steam Washer - Page 3 - Answered Questions & Fixed issues

The CL code stands for Child Lock. If you are unable to deselect the child lock function, then there could be a problem with the door latch assembly.

Unless you are a skilled DIY person, I do not recommend that you try to replace this tub bearing on the washer yourself. One has to virtually strip the entire machine to remove the tub to accomplish this bearing replacement. If you are skilled, then please supply the model number of your machine.

LG Front Load Washer Understanding Error Codes Water Inlet Valve part 5220FR2008F LG Washer Repair

Remove the countersunk screws from the door inner panel to access the handle assembly. The manufacturers part number: LG (OEM) Part #MEB61281101

Check if the counter balance weight is still attached. Sounds like a balance problem. Bruno

the filter is just before the pump on the drain line. it is inbetween the drum and pump. just remove it and replace with new one. go to appliancerepairpros.com and they have viedo

More than likely it went out on the thermal protection devise in the washer, most automatically reset after the motor cools down. Some are mounted at the rear of the washer.

Unplug take the top of an check for broken belt from motor to drum

if it does not drain it will not spin humming noise is probably something jammed in the drain pump if youre machine has a clean out you can access the inlet to the pump and clean out the debris from there if not you will have to pull the hose off . if you bail as much water as you can from the tub and tilt the machine back at a good angle it will be possible to get to the pump without having to get a shop vac to clean up the water after words.

its with '"te" error kindly check termister,,its out of order..its with heate you can find out...

drain strainer maybe clogged or drain motor dead or there is obstruction inside check hoses

you have blockage in your drain in the machine-possibly something stuck in the drain pump like a sock or a paper clip-tear it down-have a couple of old towels handy for the mess-cheers Denny

More info needed model # please

Please check this link for spares and tips: Door lock

Yes , It can be related to the control board, but first of all please make sure that there is good water flows in both the inlets, check the flow after the valve , ensure that the inlet filters are not clogged and check all the connections from the harness to the valve and panel

If it spins empty i'd check drive belt (if it has one) or motor. If it just won't spin i'd check the drain hose between tub and drain pump for debris. If no debris i'd check door switch.

Who?

Remove the top panel and you can pull the manual release.

I was going to say fit new brushes

The main switch probably needs replaced. It has its own separate motor, but if the machine goes through the earlier cycles it needs the switch. murf427