If you? Just bought a white appliance, be sure to do at least one weekly cleaning of the plastic exterior. Calm down, don't use soap and water for everything. This could be one of the reasons why yellowing starts to appear. And remember to ALWAYS remove the product from the socket before cleaning, avoiding any accident. Nobody here wants to be shocked. If it's a heavy product, which makes it difficult to turn it off all the time, remember to at least wear a rubber shoe or glove)
If your drain is not high enough the water will siphon out while filling. Check your owner's manual for correct height, usually about 39 inches from ground
This means that the water pressure switch did not return the water level in the expected length of time. Unplug the washer for several minutes (up to 10) to check for a transient error. Make sure that the washer drain isn't siphoning out the incoming water. (The end of the drain hose in the stand pipe or sink should be higher than the highest water level in the washer.) Check that the wires haven't come loose at the pressure switch. Check that nothing is blocking the air tube attached to the switch. Check the wiring harness for corrosion or damage. (Check the pins at both the switch and the control board. Make sure that the wiring harness has continuity on all of the conductors.) If the problem goes away after cleaning, then you're good. If the wiring is damaged, replace that. If the problem doesn't go away, then the pressure switch should be replaced.
If the washer won't start the wash cycle before giving the PE error, the heating element could be the problem. Check the resistance across the element.
If the washer shows the PE error when you press start or are setting a wash program, then the either there is damage to the elements that control the pressure switch or control board is damaged and has to be replaced.
If you see random PE errors, check for other loose wiring, particularly between the heater and the control board. Make sure to twist wires together securely and add shrink tubing to insulate the wires.
I hope this helps.
Cindy Wells
The child lock feature has been turned on your washing machine and when the child lock has been activated the control panel will not work and the settings can't be changed either. To turn off the child lock feature press and hold the child lock button for about 3 seconds.
There is something stuck in between the drum or inside of the washing machines tub or the bearing has worn out and should be replaced in your washing machine.
You just need to find where from?
Back of the soap dispenser.
Water Level Sensor.
Hoses under the drum.
Drain Pump.
Drain Hose.
Door Gasket on a Front Loader.
Full 'make model top load / front load' is useful in these questions
https://www.google.com/search?q=LG+washing+machine+leaks+when+filling
..
There is usually a tube next to the drum that has a sensor on it and that tube fills with water. It can get plugged up with softener or debris and then the machine wont be able to tell when it is full. To get to the tube, you must remove the tope of the machine.
Question edited for clarity.
You mean the clothes are still damp, (not dried enough) or that are as wet or wetter than you put them in? Bad dryer sensor for the former, broken water inlet valve or heater element failure for the latter.
With combined washers and dryers, there are so many things that can go wrong due to the number of sensors involved. You will need a service call from an LG technician.
