20 Most Recent
LG Studioworks 563N 15" CRT Monitor - Page 2 Questions & Answers
Moniter's Out of frequency Error
No. If you want secure uninstallation of driver. first create a system restore point.(Start> All programs> System tools > system restore)
My lg monitor shows out
just boot in safe mode
and from control panel change resolutions and frequency
set it to 1152 x 864 and 60 hz
Pincushion distortion of LG 500G
hi,
You have to check the pin control transistor in the horizontal section. It will be fitted on the same heatsik on which the horizontal output transistor is fitted.It will be a small transistor as compaired to the horizontal driver. Also you have to check the three mosfets in this section used to control the width.
ok
Lg 563n horizontal driver transistor
Look for bad solder connections in the horizontal drive circuit, especially at the horizontal drive transformer and any capacitors in the area. Ring cracks around the transformer leads are common and cause the drive signal to distort. You may also want to check the values of any tuning capacitors in the drive circuit. I've never worked on one of these so I can't give specific parts to check, but I've seen these troubles in many TVs and monitors.
Horizontal screen size is too
This is Monitor Problem.you need an monitor service engineer.the problem is in Horizontal Deflection yoke/Horizontal output transistor section.
My monitor is changing its colour itself
Try a different working monitor on the computer, if the monitor stops changing colors on its own then you know the original monitor is bad, if the same thing happens with the 2nd working monitor then you know at that point its going to be either the video card or the motherboard if the motherboard has onboard video.
No display
check whether your RAM is ok or not...
because the display problem may arise from the RAM..
My monitor is change it's colour by it shelf, Why?
This happens to me a lot. It's gennerally the connectors to the computer. Like at the back of the monitor, it might not be plugged in properly or even at the back of the computer. If this doesn't help, it is most likely inside the monitor itself.
My monitor showing half display
With limited information you provided, I would first point the finger at your video card. It may need replacing.
Secondly, it could be your video settings that need to be reconfigured. Either from the desktop access, the video program or the buttons or dials on your monitor.
Thirdly, it may be a hardware failure of your monitor. Test with another monitor.
And lastly, you may need to update your video drivers.
That's the best I can do with waht you provided.
I hope you have success
When the power on monitor led is blinking and
It sounds as though the power supply for the monitor has a problem - it may be a capacitor that is failing. It is obviously trying to turn on but the voltages are not right. The simple solution may be to replace the power supply board, but take it to a reputable electrical/electronic repair man.
Not finding what you are looking for?