20 Most Recent
Hotpoint Aquarius WMA42 Front Load Washer - Page 3 Questions & Answers
No water supply error
is it dirty water
possible it is from the sink when you do your cleaning
the pipe needs to be lifted higher
2/12/2014 9:06:42 PM •
Hotpoint...
•
Answered
on Feb 12, 2014
H20 ERROR SPIN DRYING
The error indicates a problem with the incoming water supply.
Check for restricted or kinked inlet hose/s, check that tap/s are fully turned on and that you have adequate water pressure.
1/24/2014 12:31:51 PM •
Hotpoint...
•
Answered
on Jan 24, 2014
Replace door seal
its quite easy on this machine,you can view a video on Espares.co.uk or remove front panel ,seven screws 4 top 3 bottom unclip wire on seal at front seal has two large clips to secure one outer and one inner, I find it best once the front panel is loose to unscrew the door interlock to fully remove cover once this is done you can see the workings and the exposed seal good luck.
11/3/2013 9:36:24 AM •
Hotpoint...
•
Answered
on Nov 03, 2013
Water does not drain away.
You may have a clock in the hose. If the rinse cycle doesn't work it could be a board problem. Try unplugging the machine first to reset the board. Also try to see if the end of the drain hose has anything in it that is blocking the water.
10/15/2013 8:28:57 PM •
Hotpoint...
•
Answered
on Oct 15, 2013
Aquarius filter
its located within the sump hose ,located bottom of drum and connected to pump, its a black hose with white clips.Plastic filter is in here..
10/2/2013 9:27:31 PM •
Hotpoint...
•
Answered
on Oct 02, 2013
Hotpoint wmf 720 H20 fault
If it tries occasionally to fill on rinse for a short time and pumps out/drains if the hose is flat on the floor but the programming seems off, its the motor carbon brushes worn down.To prove it if you have no spares, remove the brush holders and gently stretch the carbons out of the holders a little bit so that they touch the commutator in the motor when refitted. The copper pigtail will usualy give about 2mm stretch if you are careful.It will maybe work for a few days whilst you get new brushes.
9/19/2013 1:42:58 PM •
Hotpoint...
•
Answered
on Sep 19, 2013
There is something stuck in between the drum and
Disconnect the machine. If you can get hold of a wire and put it in between the drum and the cover. If that does not work get out the manual, and look for how to open the drum.
If the manual does not help you, try screwing the back off and lift the drum and put a wire in between the drum and the cove. I hope you can loosen what seems to be stuck.
Kolbrun
8/30/2013 6:18:11 PM •
Hotpoint...
•
Answered
on Aug 30, 2013
Not finding what you are looking for?