20 Most Recent
Hotpoint Aquarius WD640 Front Load Washer/Dryer - Page 3 Questions & Answers
With flashing light f 12
F12s low water pressure, normally either te taps stuck or the fill hose is kinked/blocked
12/28/2014 4:22:28 PM •
Hotpoint...
•
Answered
on Dec 28, 2014
We have F-13 flashing. Can you please advise what
Error code F13 indicaters dryer fan or dryer thermistor faulty.
These are to be be found in the top of the washer on top of the heater manifold.
To access them remove top cover.
Please rate my solution.
Thankyou.
12/23/2014 5:25:25 PM •
Hotpoint...
•
Answered
on Dec 23, 2014
Condensed dryer keeps tripping out my electric when I turn it on
Disconnect from mains. Remove rear panel and water will probably come out. This water is being flung by the fan onto the heater hence tripping the electric.
cause of water being here is a blockage in the condenser stopping flow into water chamber or possibly but unlikely, failure of the pump
11/25/2014 11:48:55 PM •
Hotpoint...
•
Answered
on Nov 25, 2014
Bypass the timer switch
Fit new timer switch to avoid heating if you bypass it it will go flat out and burn out the element.
11/15/2014 9:49:49 PM •
Hotpoint...
•
Answered
on Nov 15, 2014
Not drying
Is it still under warranty? I've read that these machines are better left at the retailer...
11/15/2014 9:17:38 PM •
Hotpoint...
•
Answered
on Nov 15, 2014
The washer comes up "TEST" instead of the
Hello &
Welcome to FixYa
Someone accidentally put it into TEST mode and to get it out of
the test mode follow this:-- Unplug the washer for 4 minutes and then plug it
back and press start, the display should go daft. Press start again and the
display should settle down. Now press the on/off button and the start button at
the same time and hold them down for a few seconds until the display shows
d-end or d-off. Please get back to me if you have any other
questions.
Kevin
9/20/2014 9:27:25 AM •
Hotpoint...
•
Answered
on Sep 20, 2014
THIS MESSAGE COMES UP ON THE DISPLAY
See my other reply to your request. It took me less than 2 secs on a search of your listed model to find a manual. One thing it says in the troubleshooting section is that if it fails to start with something showing on the display is to press and hold the start button for at least 3 seconds and the machine should start. See imagebank.indesitcompany.co.uk/brochures_online
8/29/2014 12:43:40 PM •
Hotpoint...
•
Answered
on Aug 29, 2014
This message comes up on the display how do i remove it please
Where is your user handbook? If you don't have one go online to the OEM who have most current models available for free download. If not get the model and serial number and search online. Call a local appliance agent for your brand, if they have a repair facility they may have a man who know's?
8/29/2014 12:36:11 PM •
Hotpoint...
•
Answered
on Aug 29, 2014
Not finding what you are looking for?