Transmission level
I have just received the following info from Brother Support:
To adjust the transmission level on your fax, please follow these instructions:
- Press the following buttons in quick succession: (MENU, *, 2,8,6,4) These must be pressed in under 3 seconds. If done correctly, the screen will display maintenance, but if it does not, press STOP and try again until it does.
- Once maintenance is on screen, press 1, then 0. The screen will display WSW00.
- Press 13, and the screen will display WSW13=01011110
- Press the right arrow on your control panel until the cursor is underneath the 3rd last digit, and press 0. Your screen should show: WSW13=01011010
- Press SET
- Press STOP
- Press 99 to exit maintenance mode, and once back to the time and date screen, send a single page fax to 1300 368 999 and you will receive a faxed reply that will show you your transmission level and how much it has been adjusted.
Please note if your transmission level is still not in an acceptable range ( -15dB to -18dB ) then it would be best to contact the Product Support Centre on the number listed below to discuss possible fixes.
I hope this helps.