20 Most Recent Hoover AAA160 Front Load Washer - Page 7 Questions & Answers

Very often the service guide and wiring diagram is hidden in the top console or in the upper part of the body stuck to the wall is a plastic bag. There might be a Service Manual, but you need the numerical model number rather than the fancy name '500'. https://www.google.com/search?q=hoover+500+washing+machine+service+manual ..

Too many clothes, not enough water, usually. However, this is a known issue on this Australian Washer. Throw it out, and buy a Front Loader. They take more laundry, use less water and electricity and don't tangle. https://www.google.com/search?q=HOOVER+500MB+WASHING+MACHINE+tangles+clothes ..

Turn it off at the mains. Leave it an hour and start again. Here is your manual in case you need it https://www.manua.ls/hoover/hn-6135/manual and even a 1 hour video :>)

Hoover Nextra HNWF6135 Washer Dryer - YouTube

https://www.youtube.com > watch 1:03:21 this is another of your choice! hoover nextra doing a cotton 40. please take a look at my amazon.

Crackling certainly doesn't sound good. How many days past warranty. Contact them, " 2 weeks ago my washing machine stopped working, I was going on a business trip, and couldn't do anything about it. I checked the fuse and it had blown. I replaced the fuse and it still doesn't work. When the machine failed it was in warranty, please come and fix". If not, the most likely issue for 'crackling' would be the control board or the motor, leaning slightly to the control board as it has no power visible to it. A failed motor would have power to the board, but nothing happening.

Faulty control panel

Possibly the control board is failed.

Easy peasy! Just fixed the same problem! Unplug machine..Take lid off machine.. Look behind program selected and unplug from circuit board (don't be scared! Try and unclick from inside the select know with small screwdriver then spray some contact cleaner in front hole and over the contacts to circuit board. It's ok.. Disolves and dries really quick.... I used the wd40 one me.. NOW NORMAL WD40!!) then put know back on and give it a good turn in both directions. Put all back together and problem should no longer exist.

COULD BE ANY NUMBER OF THINGS. CONTROL BOARD . MOTOR , TRANSMISSIN, CALL A LOCAL REPAIR SERVICE

I would suspect the transmission has gone out .but with out any testing no one can ever be sure

Error code E01 indicates a defective door latch or associated wiring or connection to control board.

There is a common issue with those machines and the wiring harness, when the machine spins, the drum causes the wire harness to flex and vibrate and this can cause the wires to break loose. To check this you need to unhook and unplug the unit and drain it, Then you can lay it down and look under it to see what is causing the issue;

Most likely is the lid lock. Logic board will not allow spin to take place if the lid is not locked.

https://www.espares.co.uk/advice/careandmaintenance/how-to-fix-an-e08-error-code-on-a-hoover-washing-machine

CONTACT A DEALER OF THAT MAKE

https://www.espares.co.uk/advice/careandmaintenance/how-to-fix-an-e10-error-on-a-hoover-washing-machine ..

Your Hoover could have a stuck cycle timer, a defective control board, or failure of some controlled element, for example the pump.

https://service.hoover.co.uk/advice-centre/the-letter-h-and-a-number-has-appeared-in-the-display-of-the-washing-machin/

fixya does not sell Hoover parts. check with an appliance parts supplier or directly with Hoover.

Defective power switch and/or cycle timer

Is usually a sign the washtub suspension is worn or broken.