Top 20
Hoover AAA160 Front Load Washer - Page 9 Questions & Answers
I have to replace an
Hey there.
The 600MB agitator is held on by a 10mm bolt only.Not sure about the plastic part that you are describing.
All you need to do is pull the stem out (the big bit with the filter on the bottom), then unscrew the bolt from the top with a 10mm socket and ratchet (with nice long extensions), and lift the agitator off (it may need a little force as they often get stuck over the years).
Install the new bit in reverse order, and dont need to go overboard tightening the bolt as it can snap..
My Hoover vhd 8142 washer wont turn. Some clothes
Sounds Like the friction on the belt.If the drum got stuck the motor & belt keep turning plus the drum may of been pulled to an off set angle distorting the alinement's of the belt to the wheel that turns the drum.
E15 fault
That is a tricky question. At times the manufacturer knows they have a bad board and will have a alternate board available like when people like yourself have trouble. This avoids them calling a recall. I have found over the years that Amazon. Com has provided great info in the review area of what people left in their comments. I have even found situations where I could go back to the manufacturer and demand a new board, with only paying the shipping. Other suppliers stay mum because they want the sale. I always "SHOP AROUND" on all parts and research the the cause of failers and watch for warranties, so that I know that I'm getting the absolute best solution for my customers. In your case I would contact the seller and see what they have to say. I hope you dealt with a good supplier who will honor their parts. Other than that the control chips should be programmed and ready to go.
I have a Hoover 500mb,
have you done a clean ,hoover have this built in you need to do every so often the filter could be clogged do a clean don't put anything in when your doing this ,how old is it
Hoover washing machine error code16 has come on
Hi!
Baically, Hoover washing machine error code E16 means that there are problems with the insulation of the heater. this may lead to the shutdown of the circuit breaker and other random errors, but this is difficult to prove without replacing the heating element.
Not finding what you are looking for?