Top 20 Hoover AAA140 Front Load Washer Questions & Answers


Hi Steven,if its not having a burnt smell it must be just water vapor,I Iive in this tropical part of the globe so we don't see much of this vapors coming out of our washing machine after spinning..I hope its just some kind of temperature difference and not an expensive problem.Its ok to tell us more of what you are observing,have a nice day amigo !

Hoover AAA140... | 36 views | 1 helpful votes


I have hoover vision hd 1400 aaa
In proble stain blaster
I oll redy clean thing and check water vest pipe
Nothing to blocking

Hoover AAA140... | 202 views | 0 helpful votes


Hi Agira,here's a link to your problem code.

Hoover AAA140... | 458 views | 1 helpful votes


Possible this can be the brushes or the bearings and you can get some tips from the links below:
motor bearings

motor brushes

Hoover AAA140... | 578 views | 1 helpful votes


Possible that the program has to be reset, remove power for some time and allow the residual voltage to drain off by pressing on all panel buttons. switch on and try again, if not check with another program cycle before the controller is suspected..

Hoover AAA140... | 162 views | 0 helpful votes


could be your filter is blocked or the pump has jamed try cleaning filter first

Hoover AAA140... | 59 views | 0 helpful votes


sometimes small objects like coins and buttons that came off our cloths makes the noise.See if something would fall if you turn it upside down,that is the simplest thing to do without using a tool.Good luck

Hoover AAA140... | 147 views | 0 helpful votes


Hi from retired Englishman in SW France,

Being from the UK I am amazed that vendors elsewhere seem not to supply manuals automatically with each machine!
???
Manual
You will need to type into your search engine/web browser '(make model number) washer manual' and you should be presented with a number of sources from which you can either download for free or have to pay a nominal amount.
You could also try the manufacturer's web site direct ;-0)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

Hoover AAA140... | 348 views | 4 helpful votes


Hi from retired Englishman in SW France,

'E02' decodes as 'fill time-out (slow fill)'.
If you have checked that the water taps are turned on fully and the hoses are not kinked or squashed at the back, it is worth while checking the water inlet filters. Turn the taps off and remove the water hoses at the washer end. Inside the inlet ports there are normally little filters which should just slide out. Clean if necessary and replace them and the hoses. If after turning the taps back on there is no improvement, the problem is symptomatic of a malfunctioning water control valve (hot or cold- difficult to judge without being there). Sorry but it needs replacing and a service call ;-0(

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck,
John C

Hoover AAA140... | 511 views | 1 helpful votes


Hi from retired Englishman in SW France,
(The filter should be just inside the tube behind the 'thing' you unscrew! You should not need to get behind that area as the drain motor is immediately behind the filter and can be checked for debris- see my guidance notes!)

Here are my complete and general pre-typed (!) guidance notes for checking both the drain filter and the drain motor ;-0)
-------------------------------------

If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!) and most are held in by a round cover/knob.

REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT!
It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. If it doesn't work then the motor is malfunctioning!

Hope the filter is the problem and good luck!
John C

Hoover AAA140... | 76 views | 0 helpful votes


hello check the belt first it might have come of or snaped if ok check the door interlock if this ok then cause could be the brushes on the motor these are made of carbon and wear down can cause the motor to stop working these sit on either side of the motor 2 plastic blocks they just slide out hope it helps

regards
shaun

Hoover AAA140... | 60 views | 0 helpful votes


Indicates a fault with the heater or the thermistor (temp. sensor). Both located at the bottom rear of the drum.

Hoover AAA140... | 54 views | 0 helpful votes


hi try the motor carbon brushes easy to change probably worn down

Hoover AAA140... | 46 views | 0 helpful votes


Check the brushes in the motor, replace if less than 3 or 4 mm long.
If prob still persists, then the control board is probably nfaulty.

Hoover AAA140... | 456 views | 2 helpful votes


Check the brushes in the motor, replace if less than 3 or 4 mm long.
If prob still persists, then the control board is probably faulty.

However

  • If your washer spins but does not pump the water out, the drain line is probably clogged. In many washers a small sock or other piece of clothing can get between the clothes tub and the outer tub that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that is attached to the pump or even into the pump itself. It it's in the pump, you need to remove the hoses from the pump and pull the item out.
  • To remove the item from the outer tub port, open the washer's main access panel and remove the large diameter rubber hose that connects the pump to the bottom of the outer tub. Using a needle-nose pliers, try to grab and remove the stuck item through the port.
  • Check your washer for a frozen pulley. Remove the pump from the washer and try to rotate the pulley manually. If it doesn't turn freely, it's frozen, replace it.
  • If the water that pumps out of the machine goes back after the spin cycle, your washer is siphoning the water from a laundry tub that has a slow drain back into the washer. The usual remedy for this is to improve the draining of the laundry tub.
  • Also check for these problems:
  1. If the drain hose reaches more than 4 inches into the laundry tub, cut the excess.
  2. If your drain hose is lower than the washer's cabinet, install an air gap/siphon break assembly.

Hoover AAA140... | 55 views | 0 helpful votes


couple choices you have you can call hoover and they will send it directly to you at 01204 556 111 or you can goto www.2ndwave.co.uk/manual.html



and download it yourself hope this helps please remember to rank how this has helped you solve your appliance problem and if i can help you in any further way please message me back thankyou again
rickead1

Hoover AAA140... | 359 views | 0 helpful votes


go here they will give it to you free http://service.hoover.co.uk/manuals/
hope this helps please remember to rank how this helped you and if i can answer any further questions please write back otherwise have a great day

Hoover AAA140... | 552 views | 1 helpful votes


Hi,

I lost a user manual, then found this site called find my manual. They emailed it to me in about 2 hours and it only cost about £3, which i thought was very reasonable.

http://findmymanual.com/

Hope this helps.
Jane

Hoover AAA140... | 233 views | 0 helpful votes


hello first thing to check is see if the belt as snaped, if ok then it may be down to the brushes on the motor you will have to take the back off to check . you should see 2 black plastic clips on the motor . the motor may be located at the bottom of the washer. hope it helps

regards
shaun

Hoover AAA140... | 46 views | 0 helpful votes

Not finding what you are looking for?
Hoover AAA140 Front Load Washer Logo

91 questions posted

Ask a Question

Usually answered in minutes!

Top Hoover Washing Machines Experts

peter gittos
peter gittos

Level 2 Expert

247 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Poppa Maddo
Poppa Maddo

Level 2 Expert

372 Answers

Are you a Hoover Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hoover Washing Machines

  • Hoover Washing Machines

Most Popular Question

when emptying machine after spin water

  • Washing Machines
Loading...