WP35-6465 is the pump number it is about
$50.00 if you buy and install. Call a Repair shop and ask them for the price of parts and labor. I don't know how old your machine is so weigh the cost of repair to a new machine.
THIS MAY be your defective part!
BE VERY careful handling this switch because it's quite delicate!1885374 "PRESSURE SWITCH" $89.68
Use THIS LINK:
http://spares.bigwarehouse.com.au/index.php?cPath=64618_64688_109010
These YOUTUBE video MAY help you!
Here is another YOUTUBE that discusses "Pressure Switches"... and that MAY be your problem. KNOW this is general information and not specific to your Hoover!
Diagnosing Washing Machine Pressure Switch Problems
How to Resolve Pressure Switch Problems in Washing MachineHoover and Candy Washing Machine Error Codes
TROUBLESHOOTING Link:
Dynamic Model No DST10146P 80 Product Code 31003253
Another snip-it:
..."Kg MODE Indicator". On Cotton and Synthetic cycles, during the first 4 minutes of the cycle the intelligent sensor will weigh the laundry and adjust the cycle time, water and electricity consumption accordingly. ...
More: The intelligent KG Mode sensor weighs the laundry and adjusts the cycle time, water and electricity consumption to suit the size of the load. This gives you the optimum consumption even if you are only washing one shirt.
The intelligent KG Mode sensor
During the first minutes of the cycle, the "Kg MODE" indicator remain on while the intelligent sensor will weigh the laundry
and adjust the cycle time, water and
electricity consumption accordingly.
• Through every wash phase "Kg MODE"
allows to monitor information on the wash
load in the drum and in the first minutes
of the wash it:
- adjusts the amount of water required;
- determines the length of the wash cycle;
- controls rinsing according to the type of
fabric selected to be washed it;
- adjusts the rhythm of drum rotation for
the type of fabric being washed;
- recognizes
the presence
of lather,
increasing, if necessary, the amount of
water during rinsing;
- adjusts the spin speed according to the
load, thus avoiding any imbalance.
Easy peasy! Just fixed the same problem! Unplug machine..Take lid off machine.. Look behind program selected and unplug from circuit board (don't be scared! Try and unclick from inside the select know with small screwdriver then spray some contact cleaner in front hole and over the contacts to circuit board. It's ok.. Disolves and dries really quick.... I used the wd40 one me.. NOW NORMAL WD40!!) then put know back on and give it a good turn in both directions. Put all back together and problem should no
longer exist.