20 Most Recent Hoover Nextra HNWL 3126 Front Load Washer / Dryer - Page 5 Questions & Answers

I would suggest that you turn the programmer to the stop position then leave it for a few minutes and then reprogram.

there are many models most common one has a bolt located at the bottom of the inside of the agitator remove cap to see it you will need several extensions,10mm socket and ratchet

this place sells one so i guess it does! HOOVER 500M Parts List BigWarehouse Spares

I have a similar problem,
Have to slap the door to get it to start. I’ve changed the interlock but still the same... any suggestions? Could it be the door rather than interlock?

CL (child lock) has been enabled. To disable hold down the child lock button for 3-5 seconds.

https://www.amazon.com/Genuine-HOOVER-NEXTRA-Washing-Machine/dp/B00COPRWY6

You have faulty transmission or/and clutch. Clutch is on the bottom of the transmission , next to the pully.

You have had a leak. You can disconnect the hose and empty all the water out of it, then leave the hose in the sun to heat up, this will SOMETIMES reset the water stop, if not you will need a new hose.

Error code E09 means there is something the matter with the part in the washing machine control board that drives the motor. Fixing a control board error can be complex. You can try: Switching off and unplugging your washer when you do this i suggest waiting about 5 minutes before plugging in since your machine can store energy even after a few seconds of being unplugged. Checking the wiring and connections to the control board