Top 20 Hoover Nextra HNWL 3126 Front Load Washer / Dryer - Page 8 Questions & Answers

See THIS Link... Item 1548793. MORE 500M parts here: HOOVER 500M Parts List BigWarehouse Spares

if you unplug it from the wall does the dripping continue? if so the inlet valve is jammed slightly open and will need to be replaced (on the odd occasion i have had success by giving it a sharp tap) in the meantime turn the taps off when your not using the washer

Does your Hoover model have a tub-to-sink hose? When pumping does it seem like the volume is what it used to be? If not, you may have some restriction in the pump or the hose. It could also be that the timer isn't running the pump long enough. Does it seem to pump for the normal amount of time?

check if the belt has come off or snapped.......cheers

SOUNDS LIKE A DRAIN HOSE LEAK

Check the lid switch is working when you put lid down.

https://www.repairclinic.com/RepairHelp/Washing-Machine-Repair-Help Washing Machine Repair Help

It is under warranty call service, do not attempt any repairs as it will void the warranty.

I would suspect the main board has failed.

Sounds like electrical leakage to earth operating a circuit breaker, this can be caused by many things however perhaps most common is the Heater in the machine, disconnect both wires to this bottom of the drum then try machine to see if it powers up, if yes then get/fit new heater .

If it has a dispenser it will be clearly marked.

In most washers, the reversing mechanism in the transmission broke. You probably will have to replace it.

faulty timer or circuit board

Not sure what you mean by a "rotor disc"??? According to the diagram It only has 1 belt. HOOVER WASHING MACHINES 550MB 01 Parts select exploded view 010

door switch faulty or wants adjusting .

The only way is to disconnect from power if the door does not open within the specified time then you need to open the top of washing machine and get access to the electronic switch then tak it off do this without power this will open the door and if can test the swich if faulty you can get replacement from washing machine spares on internet google it hope this helps

water pumps seldom fail most likely the solenoid that controls the pump operation or the program control board operation

how old is the 7 kg washing machine should be direct drive to the drum not a belt drive the motor could be wearing out are you over loading

The main seal has allowed water into the spin bearings...

as you have probably found out by now the drum bearings are worn out probable due to the seals leaking ,new set of bearings and seals if not already fitted.